1968 Mercury Cougar

Console wiring harness for 1967-68 Standard Cougar any all Mustang. This harness is for the light in the roll up garage door compartment and the rear console lights. There is a jumper wiring harness also available, that connects to the main under dash harness. See related items. Ford part number C7ZB-13B711-A. *Note - Not for Mercury Cougar XR7 models.

Differs from all other Cougar console wiring in that it has a blue, double female plug for the shift indicator light

Wiring harness for the low fuel sending units on 1968 Mercury Cougar XR7 and standard models with low fuel warning light. The Safety Convenience Option included a low fuel warning light. This harness has two wires which attach to the three prongs on the 1968 C8ZF-9275-B low fuel sending units.1967 and 1968 will interchange, 1967 has a plastic shielding on the end of the wire loom that is under the car. 1968 version does not have this shielding. Ford part number is C8WB-14406-A or C8WY-14406-A....

Used upper wiring harness for the overhead console on the 67 - 68 Cougar XR7. Sometimes known as the Convenience Group Harness. This harness runs under the headliner from the overhead console back to the C pillar, where it connects to the lower harness. You can get the lower harness here. Ford Part Number C7WB-10C877-F

Used grade A standard 14405 harness is inspected, professionally repaired, tested, and ready to install. This harness connects to the main 14401 under dash harness at the passenger side door jamb, and runs through to the trunk. It connects to the sequential unit and the fuel sending unit.These grade "A" harnesses will be uncut and unburnt. This is for those of you who demand excellent original parts for your Cougar.

Used grade B standard 14405 harness is inspected, professionally repaired, tested, and ready to install. This harness connects to the main 14401 under dash harness at the passenger side door jamb, and runs through to the trunk. It connects to the sequential unit and the fuel sending unit. Grade "B" harnesses may have one or two repairs where the grade "A" harnesses will be rare uncut and unburnt beauties.

Used XR7 14405 harness is inspected, professionally repaired (if needed), tested, and ready to install. This harness connects to the main 14401 under dash harness at the passenger side door jamb, and runs through to the trunk. It connects to the sequential unit and the fuel sending unit, and also connects to the overhead console. Ford part number C8W8-14405-F

This harness connects the rear speaker harness to the fader switch. Ford part number C8GA-18A900-BOverall length: 44"

Used Seat Belt Reminder 1968 Mercury Cougar Standard ModelThis wiring harness has an included lamp socket that plugs into your instrument cluster just below your right turn signal light.This 1968 harness attaches to the yellow accessory feed plug off the main harness, and the seat belt reminder relay (sold separately). Tested harness includes 1895 bulb, 7-1/2 amp fuse.

Quality wiring reproduction for Perfect Circle brand of speed controls as found on most 1967-1971 Ford - Mercury - Lincoln automobiles. Main harness with Ford part number 9A840, can be used on a variety of model and years. Harness connects the servo, has grommet for firewall, and connectors under the dash. Jumper wire to the brake pedal.

Factory used and tested under dash wiring harness for all 1968 - 70 Mercury Cougar and Ford Mustang cars with factory AM/FM or AM 8 Track stereo radios. This harness plugs into the speaker plug of the radio, and connects the kick panel speakers in a 1967-68 Mercury Cougar or to the A pillar post where it connects to the door wiring harness that has the speaker plug for the door mounted speakers in 1969-70 cars. White speaker wire goes to the passenger side speaker, and the orange colored wire...

Reproduction tilt / tilt away steering column wiring harness for the Mercury Cougar or Ford Mustang. Exact copy in every way! If you call and tell us the long sad story of how when you pulled your column in 1982 in a bone yard and left this harness behind unknowingly. we will have to charge you extra... Just kidding! *NOTE* For tilt column service, you can contact Tony Augustine at 6t8cougarguy@gmail.com. Tony is a trusted colleague of WCCC and we've sent many customers his way since our...

Used wiring pigtail that runs from the under hood harness at the kick panel to the starter solenoid / horn / voltage regulator on the 67 - 68 Cougar.

Emergency or parking brake indicator lamp and wiring harness. Tested and working red indicator light which was found optionally on any 1968 Mercury Cougar standard model 65A or 65C. The 1968 parking brake light kit gets its power from the ignition switch. 

For use on fixed columns only. Attaches to the bottom side of the column to keep the wiring in place. Fits all 1968-69 Mercury Cougar, Ford Mustang, Ford Torino, Mercury Cyclone.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of...

Used radio light socket and wiring pigtail for all factory Philco AM radios as installed in 1967-70 Mercury Cougar and Ford Mustang cars. These light sockets are tested and cleaned, and have enough wiring lead to re-solder or crimp connect to your Philco AM radio. Original part with correct color wire.

Original used AM radio speaker lead wiring harness pigtail for all 1967-70 Mercury Cougar and Ford Mustangs with factory AM radios. We have a limited supply of these but also offer a quality reproduction version of this wiring plug pigtail. Proper length for re-soldering to factory AM radios

Used wiring pigtail that runs from the 14290 under hood harness to the passenger side headlight harness.

New wiring pigtail with male bullet connector, and male / female paired connector. Also has rubber grommet that fits a 5/8" inch hole. Looks like 18 gauge wiring. These are remnants from the reproduction Mustang front turn signal lights that we convert to Cougar wiring. Brand new, approximately 13-15 inches in total length. Colors as shown.

Original used AM radio power lead wiring harness pigtail for the 67 - 71 Mercury Cougar and Ford Mustangs with factory AM radios. This double male plugged wiring pigtail solders to the your factory Ford AM radio. We have a limited supply of these but also offer a quality reproduction version of this wiring plug pigtail. Proper length for re-soldering to factory AM radios.

Used under dash harness repair plug and pigtail lead to the low fuel sending unit for the Mercury Cougar XR7 or Standard model with the Safety and Convenience option. This is part of the rear wiring harness, plug is at the passenger side kick panel. 

Reproduction wiring harness pigtail plug for the 67 - 68 Cougar or Mustang voltage regulator.

This pigtail is for 68 - 70 cars, but will work on 1967 cars with 8 track radio.Original used under dash speaker wiring harness pigtail for all 1967 - 70 Mercury Cougar and Ford Mustang cars with factory AM/FM or AM 8 Track stereo radios. This speaker wiring harness pigtail plug end goes to the your radio. Part of the stereo speaker wiring harness that goes to a pair of factory speakers in the kick panels in a 1967-68 Mercury Cougar or to the A pillar post where it connects to the door...

Used taillight wiring harness repair eyelet and pigtail from the circuit breaker to EACH taillight and license plate light. This harness section contains a pink resistor wire which should not be cut or spliced. That is because the wire's ohm resistance is based upon it's length. Cut it, and she's done for. This is part of the 13A449 main taillight wiring harness. *NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject....

Used taillight wiring harness repair eyelet and pigtail that is the ground wire at the fuel filler for the Mercury Cougar. This is part of the 13A449 main taillight wiring harness.Good for both STD and XR7 models.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a...

Used wiring pigtail that runs from the taillight harness ground wire to the K8 / K9 sequential motor. Will work on 67 - 68 Standard and XR7 model Cougars.

Used taillight wiring harness repair plug and pigtail connection at the driver side (left hand) door jamb on the Mercury Cougar. This is part of the 13A449 main taillight wiring harness.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of...

Used taillight wiring harness repair plug and pigtail connection at the driver side (left hand) door jamb. This is part of the 13A449 main taillight wiring harness.Good for both STD and XR7 models*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great...

Used wiring pigtail that runs from the taillight harness to the Back up light housing on the 67 - 68 Cougar. Works on both Standard and XR7 models.

Used taillight wiring harness repair plug and pigtail to the driver side (left hand) back-up light on the Mercury Cougar. This is part of the 13A449 main taillight wiring harness.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of...

Used wiring harness that runs from the taillight harness to the emergency relay on the 67 - 68 Standard and XR7 model Cougars. 

Used taillight wiring harness repair plug and pigtail to the passenger side (right hand) back-up light on the Mercury Cougar. This is part of the 13A449 main taillight wiring harness.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of...

Used taillight harness wiring repair pigtail from the K8 relay to the passenger side (right hand) door jamb for the 67 - 68 Mercury Cougar Standard / XR7

Used under dash wiring harness repair pigtail that goes from the engine feed harness to the neutral safety / backup lights of the Mercury Cougar Standard.

Used under dash wiring harness repair plug and pigtail for the console lights. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail for the door ajar / seat belt warning for the Mercury Cougar XR7. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail lead to the courtesy light in the driver side (left hand) door for the Mercury Cougar. This part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail to the low fuel sending unit for the Mercury Cougar XR7 or Standard model with the Safety and Convenience option. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail to the low fuel sending unit / K8/9 relay for the Mercury Cougar XR7 or Standard model with the Safety and Convenience option. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail leads to the map light switches to the overhead wiring harness at the passenger side (right hand) door jamb for the Mercury Cougar XR7. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail lead to the oil pressure gauge and oil pressure gauge lights for the Mercury Cougar XR7. The individual leads can also be purchased separately. This is part of the 14401 main under dash wiring harness.Check out our video below on how to use the new gauge tester: ...

Used under dash wiring harness repair plug and pigtail for the reverse / brake lights to the turn signal relay for the Mercury Cougar. This is part of the 14401 main under dash wiring harness.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great...

Used under dash harness repair plug and pigtail for the light switch harness for the Mercury Cougar Standard and XR7. This is part of the 14401 main under dash wiring harness.*NOTE* The individual wires can be removed from the block and other wires can be inserted if your car has different options.

Used under dash wiring harness repair plug and pigtail from the low fuel relay to the passenger side (right hand) door jamb for the Mercury Cougar XR7. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail for the parking brake warning light in the overhead for the Mercury Cougar XR7. This unit connects at the passenger side door jamb to the overhead harness. This is part of the 14401 main under dash wiring harness.

Used under dash harness plug and pigtail to repair the passenger side (right hand) leads to the fuel sender / K-8/9 relay for your Mercury Cougar Standard and XR7. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair power lead plug and pigtail repair for the under dash harness for the Mercury Cougar. This is a power lead for the fuse block / box and is part of the 14401 main under dash wiring harness.

Used ground wire for the relay panel next to the fuse panel / block on the Mercury Cougar Standard and XR7.