Lights

These are also a good replacement bulb for the 67-68 under-dash courtesy lights as they are easier to grip than the 631 bulb.

Reproduction 158 Interior Auto Transmission Light Bulb for the 1967 and 1968 Mercury Cougar

Reproduction 1892 Interior Exterior Light Bulb for the 1967 - 1973 Mercury Cougar

Reproduction 1893 Interior Radio Light Bulb for the 1967 - 1973 Mercury Cougar

Replacement bulb for the door ajar warning light panel. This replacement bulb does not have the flashing feature like the OEM GE 256 installed bulbs. The original bulbs have a heat tab that flashes the bulb after a couple of seconds.

Used 3 pin connector and light socket harness for the 1967-68 Mercury Cougar overhead console harness for seat belts and door ajar indicators. Blue and red light sockets. These are the same sockets for the seat belt reminder and door ajar warning lights on the ultra rare Safety Convenience Option offered in 1967-68 on both the Cougar and Mustang.

Used 4 pin connector and light socket harness for the 1967-68 Mercury Cougar overhead console harness for parking brake and low fuel indicators. Yellow and green light sockets. These are the same sockets for the parking brake and low fuel warning lights on the ultra rare Safety Convenience Option offered in 1967-68 on both the Cougar and Mustang. Do you want to replace those worn out actuators yourself or are you looking for some great information on aligning the grille in you Cat? The video...

Reproduction interior turn signal indicator 53x light bulb for the Mercury Cougar. *NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of information on the subject. ...

Reproduction 97 License Plate Light Bulb for the 1967 - 1973 Mercury Cougar

This lens comes without the correct FoMoCo logo, sold individually. Replaces Ford Part # C5ZZ-15514.

These Back-Up Lamp Lenses are exact copies of the originals which come with the FoMoCo Logo. Sold Individually. Includes screws!

Sold individually. Stainless Steel

This kit is a time and money saver. Quality chrome bezels and all related parts are included. This is a direct plug-in, no modifications needed.

Hassle free kit makes it easy to install backup lamps. This kit includes mounting pads, lenses, gaskets, T1142 Bulbs and mounting hardware.

Great chrome on this reproduction backup / reverse light for the driver side (left hand) of the Mercury Cougar or Ford Mustang. Lens, gasket, and bulb sold separately. Replaces Ford part # C7ZZ-15512.

Used backup / reverse light for the driver side (left hand) of the Mercury Cougar and Ford Mustang. Lens, gasket, and bulb sold separately, but we do have a kit available. These used lights will often have a minimal amount of pitting on the inside close up to the lens. Casting number as seen on the back side reads C7ZB-15A509-A. Replaces Ford part # C7ZZ-15512.

Great chrome on this reproduction backup / reverse light for the passenger side (right hand) of the the Mercury Cougar or Ford Mustang. Lens, gasket, and bulb sold separately. Replaces Ford part # C7ZZ-15511.

Used backup / reverse light for the passenger side (right hand) of the the Mercury Cougar and Ford Mustang. Lens, gasket, and bulb sold separately, but we do have a kit available. These used lights will often have a minimal amount of pitting on the inside close up to the lens. Perfect inexpensive replacement item for those wanting to keep their car all original and match the overall patina of their low mile car. Casting number as seen on the back side reads C7ZB-15515-A.Replaces Ford part #...

Reproduction backup light mounting spacers for the Mercury Cougar or Ford Mustang.

These courtesy light brackets are located on the very outer right and left under the dash. Typically this bracket is found on the passenger side of 1967-68 Mercury Cougar and Ford Mustang without air conditioning. This is the long style bracket. There is also a short style for both the driver and passenger side courtesy light. If you have factory air conditioning you would want the short bracket that doesn't come into contact with the A/C plenum.Replaces Ford part number C7ZB-13763-A.Fits:1967...

These courtesy light brackets are located on the very outer right and left under the dash. Typically this bracket is found on the driver side of all 1967-68 Mercury Cougar and Ford Mustang. It is also used on the passenger side if you have air conditioning. This is the short style bracket. There is also a long style for both the passenger side courtesy light if you don't have factory air conditioning. If you have factory air conditioning you would want the short bracket that doesn't come into...

Correct Backup Light Bulb for the 1967 - 1968 Mercury Cougar. Owners Manual and shop manual incorrectly state the backup light bulb to be the 1156.

Brand new 1157 (dual-filament) exterior stop lamp / turn signal light bulb for the Mercury Cougar or any vehicle equipped with 1157 bulbs. *NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of information on the subject. For even brighter...

The 67 -73 Cougar uses the 1157A (Amber) bulb for the turn signals.  This bulb will also fit other applications that require an 1157A or 1157NA bulb. Replaces bulb #: 1157A or 1157NA

Sold individually these are the very hard to find side marker bulbs for your 1968 Cougar. The 1968 Ford Manuals call for a 97N bulb but that is an error believe it or not... As shown in the NOS light below these bulbs came painted, ALL MODERN REPRODUCTIONS ARE MADE WITH AMBER GLASS (See Amber Glass Listing). The paint is very prone to chipping and after examining several NOS lights that we presume have never been opened we found a couple to have been scratched prior to being installed in the...

Replacement lamp for the speedometer, heater controls, ashtray, automatic shift indicator, low fuel, seat belt reminder, or emergency flasher warning lights on the visual check panel.

This bulb fits several applications including the door panel courtesy lights in the 1967 - 1968.

New 1895 bulb for the instrument clusters. *Note - The table and the owners manuals are wrong for the Visual Check Panel bulbs, Ford literature calls out a 1895 bulb, when in fact the correct bulb is 1891.

Reproduction 631 Glove / Luggage Compartment / Under Dash Courtesy / Trunk Light Bulb for the 1967 - 1973 Mercury Cougar

Great Reproduction of an Often Broken Part. This part fits on the bottom of the steering wheel and must be in place to cancel your turn signal on tilt column cars. Used on all Ford products with a tilt column 1967-69. *NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here...

Factory original turn signal canceling cam. Originals were molded in white, reproductions are molded in black. Repros also available from us. Without this part that self attaches to the back of your factory steering wheel, you will be turning off your blinkers manually. Click up, click down... *NOTE* We have no good reason to encourage you to purchase this hard to find original over the reproduction, unless you just gotta have it. **NOTE** Need help diagnosing a Cougar turn signal problem?...

This clip mounts the actuator shaft to the eyelids. Two required for 1967 - 1968, one required for 1969 - 1970. Same clip holds the windshield wiper motor to the wiper transmission.

This is a complete set of four used headlight bulbs, marked with the FoMoCo logo. These sets come with two high beam and two low beam bulbs. Each bulb is tested by the electrical department. If you're trying to keep your Cougar or Mustang as close to original as possible, you should definitely grab a set.These bulbs are date coded, so if you want a particular date, be sure to mention it in the comments section of your order.  

Differs from the original lens in that it is all white. The original was painted white on one half and left clear on the other.

C7WB-13K705-C-AGRADE Left side courtesy lamp assembly attached to the door panel of all 1967 Cougars and 1968 Cougars with either decor or XR7 interiors. Courtesy light assembly tag numbers as listed in the 1967 Cougar Electrical assembly manual on page 16, C7WB-13K705-C courtesy lamp assembly left hand side. This is a grade "A" premium grade harness that is not sun damaged, spliced or damaged in anyway. Hardest side to find in primo condition most get dinged up from errant seatbelts. This...

Left side courtesy lamp assembly attached to the door panel of all 1967 Cougars and 1968 Cougars with either decor or XR7 interiors. Courtesy light assembly tag numbers as listed in the 1967 Cougar Electrical assembly manual on page 16, C7WB-13K705-C courtesy lamp assembly left hand side. This is a grade "B" good used light assembly, expect minor rust pitting on the bezel and scratched lenses.Replaces Ford part number C7WB-13K705-C.Fits:1967 Mercury Cougar1968 Mercury Cougar ...

C7WB-13707-C Right side courtesy lamp assembly attached to the door panel of all 1967 Cougars and 1968 Cougars with either decor or XR7 interiors. Courtesy light assembly tag numbers as listed in the 1967 Cougar Electrical assembly manual on page 16, C7WB-13707-C courtesy lamp assembly right hand side. This is a grade "A" premium grade harness that is not sun damaged, spliced or damaged in anyway.

Right side courtesy lamp assembly attached to the door panel of all 1967 Cougars and 1968 Cougars with either decor or XR7 interiors. Courtesy light assembly tag numbers as listed in the 1967 Cougar Electrical assembly manual on page 16, C7WB-13707-C courtesy lamp assembly right hand side. This is a grade "B" good used light assembly, expect minor rust pitting on the bezel and scratched lenses.Replaces Ford part number C7WB-13707-C.Fits:1967 Mercury Cougar1968 Mercury Cougar ...

Rechromed Bezel for your door courtesy lights found on all 67-68 Cougars except the 1968 Standard model. These will require some patience with a dremel tool to remove the lenses from your cores and place them in these. Passenger and driver are the same, keep in mind the red lens goes to the back of the bezel. To be eligible for core refund, your cores can only show light pitting. ...

This plastic socket is very brittle and almost always breaks when installing a new door jamb switches. Does not fit cars with Warning Group with door ajar option. Simply install by carefully breaking the old brittle plastic socket apart with pliers to free up the wire leads and plug wire leads into the new socket.

Good used dash toggle switch that operates the courtesy (rear opera) lights in the Mercury Cougar. These switches will have no rust or broken wires and the plastic toggle switch tips are sold separately. These used switches move freely and are guaranteed to work. The only real difference between the years, besides the size of the shaft, is the toggle switch tips. That is why we are offering both 1967 and 1968 versions. There are three versions of shafts used on the 1967 - 1968 XR7 toggle...

Good used dash toggle switch that operates the driver side (left hand) map light in the Mercury Cougar XR7. This switches will have no rust or broken wires, moves freely, and is guaranteed to work. Plastic toggle switch tip is sold separately. The only real difference between the years, besides the size of the shaft, is the toggle switch tips. That is why we are offering both 1967 and 1968 versions. There are three versions of shafts used on the 1967 - 1968 XR7 toggle switches and all three...

Good used dash toggle switch that operates the passenger side (right hand) map light in the Mercury Cougar XR7. These switches will have no rust or broken wires and the plastic toggle switch tips are sold separately. These used switches move freely and are guaranteed to work. The only real difference between the years, besides the size of the shaft, is the toggle switch tips. That is why we are offering both 1967 and 1968 versions. There are three versions of shafts used on the 1967 - 1968 XR7...

Good used dash toggle switch that operates panel (under dash) lights in the Mercury Cougar XR7. This switches will have no rust or broken wires, moves freely, and is guaranteed to work. The only real difference between the years, besides the size of the shaft, is the toggle switch tips. That is why we are offering both 1967 and 1968 versions. There are three versions of shafts used on the 1967 - 1968 XR7 toggle switches and all three feature the same C7WB-13713-A engineering number. 1967...

Used diffuser for the shift indicator lamp. This diffuser is used on the Cougar or Mustang WITH a console and attaches to the end of the light socket on your shift indicator wire harness. Both shift indicator lamps with or without a console used the same wire harness and socket, but used different diffusers. The difference in the harness from the 67 to the 68 was different colored wires and different plugs. Replacement bulbs can be found on our site as well. ...

Used diffuser for the shift indicator lamp. This diffuser is used on the Cougar or Mustang WITHOUT a console and attaches to the end of the light socket on your shift indicator wire harness. Both shift indicator lamps with or without a console used the same wire harness and socket, but used different diffusers. The only difference in the harness from the 67 to the 68 was different colored wires.

68 - 70 Courtesy Light Switches! These replacement switches are an exact reproduction of the original Ford part. This is the 2 pin type. Includes original Autolite Logo. Many 70 - 73 cars used 3 pin type switches for the optional automatic seatback release feature. Sold individually. Additionally, this switch for the 3/4 inch mounting hole was used on 1968-70 Full sized Ford such as Custom, 500, Galaxie, LTD, and XL models, full sized Mercury such as Monterey, Montclair, Marquis, and Park...

3/4" wide and 60' long. This tape resembles the tape you would find on bicycle handle bars or a hockey stick but is in fact different. The taillight harness uses this type of tape as well as portions of the under dash harness. Not used in modern applications and getting rather hard to find these days.NOTE: This is FRICTION tape not adhesive tape. It is coated with rubber and relies on friction with itself to wrap wires. It does not stick to the wires. This was one of the first types of...