1969 Mercury Cougar

Used under dash wiring harness repair plug and pigtail for the emergency flasher for the Mercury Cougar. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail for the courtesy lights on the door or dash for the Mercury Cougar. The plug is the same for both left and right sides. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail lead from the low fuel relay to the sending unit. This unit connects at the driver side (left hand) door jamb. This is part of the 14401 main under dash wiring harness.*NOTE* This is the same plug for the Standard model that is equipped with the Safety and Convenience option, but it comes in different harness # 13A769.

Used under dash wiring harness ground wire repair plug and pigtail for the Mercury Cougar. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail lead from the ignition switch for the Mercury Cougar. This goes thru the neutral safety plug to the starter solenoid. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail lead to the door ajar switch on the Mercury Cougar XR7 or Standard model with the Safety and Convenience option. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail to the light switch for the Mercury Cougar. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtails to the connecting block at the fuse block / box for the Mercury Cougar. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail to the turn signal sequencer from the turn signal switch for the Mercury Cougar. This connection is made from the driver side (left hand). This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail for the turn signal flasher for the Mercury Cougar. This is part of the 14401 main under dash wiring harness.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of information on the...

Used under dash wiring harness repair plug and pigtail to the blower resistor box for the Mercury Cougar. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail to the blower switch for the Mercury Cougar equipped without A/C. This is part on the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail to the brake pedal switch for the Mercury Cougar. This is part of the 14401 main under dash harness.*NOTE* The pigtail for this plug features the same wire colors and configuration as the 1967, but the wire gauge is heavier for 1968.

Used under dash wiring harness repair plug and pigtail to the brake switch circuit breaker for the Mercury Cougar. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail to the cigar / cigarette lighter for the Mercury Cougar. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail to the dimmer switch on the Mercury Cougar. This is part of the 14401 main under dash wiring harness.

Used wiring pigtail from the under dash harness to the door jamb switch on the driver side of the 69 Standard Cougar.

Used wiring pigtail from the under dash harness to the door jamb switch on the passenger side of the 69 Standard Cougar.

Used under dash wiring harness repair plug and pigtail to the emergency brake switch on the Mercury Cougar. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail to the instrument panel for the Mercury Cougar Standard. *NOTE* The pin configuration on this plug will vary with the individual car and it's options.

Used under dash wiring harness repair plug and pigtail to the instrument panel for the Mercury Cougar XR7. This is for cars with A/C and used on car produced after 3/3/1969. *NOTE* The pin configuration on this plug will vary with the individual car and it's options.

Used under dash wiring harness repair plug and pigtail to the low fuel relay for the Mercury Cougar XR7. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail to the map light for the Mercury Cougar XR7. This is part of the 14401 main under dash wiring harness.

Used wiring pigtail that runs from the under dash harness to the parking brake light on the 69 - 70 Standard model Cougar.

Used under dash wiring harness repair plug and pigtail to the seat belt waring switch for the Mercury Cougar. This is part of the 14401 main under dash wiring harness.*NOTE* The pigtail and wire colors are the same, but are in different locations on the plug prior to 3/3/1969.

Used under dash wiring harness repair plug and pigtail to the rear taillight harness for the Mercury Cougar. This is part of the 14401 main under dash wiring harness.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of information on the...

Used under dash wiring harness repair plug and pigtail to the turn signal switch for the Mercury Cougar produced after 3/3/1969. This is part of the 14401 main under dash wiring harness.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of...

Used wiring pigtail that runs from the 14401 main under dash wiring harness to the wiper motor.

Wiring pigtail that runs from the main 14401 under dash harness to the neutral safety switch on the 1969 Cougar.

Reproduction under hood wiring harness repair plugs and leads that go from the under hood harness to the starter solenoid on the Mercury Cougar or Ford Mustang.  Sold as a pair.

Used under hood wiring harness repair plug and pigtail connection to the under dash harness at the fuse block / box for the Mercury Cougar XR7 produced after 3/3/1969. This is part of the 14290 under hood wiring harness.

Reproduction wiring pigtail repair kit for the sequential box on the 1969 - 1973 Cougar.  Included are: 1 five pin red connector1 five pin black connector

Reproduction ignition switch repair pigtail for your 68-69 Cougar and Mustang. This pigtail is not going to be a good fit, but if you choose this as your replacement, keep in mind that although this pigtail has an extra long resistor wire, do not splice into it or cut it down. Its resistance is dependent on its full length. This is a  cheap, inexpensive replacement, but we don't recommend it and would highly suggest going with one of our used pigtails instead.  NOTE - We've...

Used steering column wiring harness plug aka Turn Signal Switch Harness Connector. Replacement plug for all 1970-72 Mercury Cougar and Ford Mustang, with tilt or fixed steering columns. Generic Ford part likely lots of applications between 1968-69, Ford, Mercury, & Lincoln. This plug is black, there is also a natural or white color version of this plug used by Ford 1968-69. Ford part number D0AZ-14489-L.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the...

Correct plug for your 67-71 AM- FM radio, or 8-track... Often these have been cut from the main loom to install an after market radio.The 1972 model used the same plug, but the wires are not in the same spots, go figure! These are speaker wires not power wires.The color codes are:  White right cowl speaker.   Orange left cowl speaker. Speaker blue / black ground. Power "not this listing." Blue / red stripe, radio light. Yellow / black stripe, power in for radio. ...

Exact replacement for that valuable AM-FM radio. This plug and pigtail is used to repair the radio out to speaker wiring so that it will plug into the plug for the speakers. Don't fake it and hack up your valuable under-dash wiring harness to make your original radio work! Fix it correctly the first time with this quality replacement piece.

The Wittek Company manufactured the tower clamps used on the Cougar from 1967 to 1973, the Mustang from 1964 1/2 to 1973, as well as many other Ford and Mercury cars during that period. In October or 1993, the company filed for bankruptcy. This has made the tower clamp unavailable to the classic car restorer. Our supplier was able to bid at the auction for enough of the original tooling and parts to make these clamps available again. Other companies have also reproduced these clamps, but...

Reproduction wrench or crank, for manually closing the factory installed sunroof installed on any 1967-73 Mercury Cougar. Sunroofs, technically moonroofs, were originally installed by ASC or American Sunroof Corporation. Hertz 1968 XR7-G cars all came with factory sunroofs, as did the Hertz rental 1969-70 Cougar Eliminators. ASC also installed sunroofs in Ford Thunderbird, Lincoln MK III.ASC used Golde mechanical parts from Germany. Golde was a manufacturer of sliding canvas and metal roofs on...

This direct replacement is the 2 inch Y pipe only with 2-1/4 intermediate pipe outlets and is for any 1969-70 Mercury Cougar or Ford Mustang equipped with the 351W engine with stock cast iron exhaust manifolds. These units are manufactured right here in the good old USA from 2 inch aluminized pipes and made from an original 1971 Cougar and Mustang with the 351W 2V engine. We also sell OEM style dual exhaust systems that include the H pipe, mufflers, and tail pipes.*NOTE* Will not fit 351...

Reproduction engine side stud for the clutch equalizer bar or z-bar that fits a 289, 302, 351W, or 351C engines in the 67-70 Cougar or Mustang. 

NOS (New Old Stock) rear pancake motor for the rear quarter windows of the Mercury Cougar or Ford Mustang. These motors are often ruined because water has leaked down into the quarter panel where it has then seeped into the motor. Once water gets inside the case, the motor's days are numbered. This is because the interior of the case will eventually start to rust and it will seize the motor. This motor is a service replacement part and it would have been the motor your local dealership would...

We recently unearthed a few of these unused club decals from the 1980's. "Cougars Northwest" was one of the earliest Cougar Clubs in the country. It folded back in 1988. It was amazing to witness the number of XR7G's, GTE's and Eliminators that would appear at the various club functions such as the annual "Cruise To Cougar Washington". Check out the very first Cougar in our video below! ...

Reproduction gold dichromate 13 blade alternator fan. Used on 1967-69 Mercury Cougar and 1965-69 Ford Mustang manufactured BEFORE 11/17/1969. Actually this is a Ford part found on almost all Ford automobiles from 1965-69. 13 blade alternator cooling fan.Replaces Ford part #: C5AZ-10A310-B.

1969 Cougar XR7 1/43 scale mini trophy model kit. No glue required, simply snap together the pieces and put the car inside the included plastic "trophy case". We haven't seen many of these collectible kits around the web, it's definitely a hard to find example. Previously owned, there's no plastic bag to contain the parts like the usual model kits, everything comes inside the clear plastic case show in the photos. Some pieces have broken away from the attaching ribs, but it looks like...

NOS factory sealed 1969 Mercury Cougar model kit from the original AMT Corporation in Troy Michigan, Model #Y 908 200. Advertised 1/25 scale kit reproduced from official factory prints. We've seen a few of these for sale, but have never come across one that is sealed. This is truly a rare find.

Used open box 1969 Mercury Cougar model kit from the original AMT Corporation in Troy Michigan, Model #Y 908 200. Box has a tear in it on one side. Advertised 1/25 scale kit reproduced from official factory prints, everything seems to be inside the box, however a few pieces have been dislodged and sitting apart from the attaching ribs. Includes original build instructions and decals. 

Used open box unbuilt 1969 Mercury Cougar XR7 Hardtop model kit from the original AMT Corporation in Troy Michigan, Model #2202. Part of AMT's "swingin sixties" kits, this Cougar can be build stock or custom with Kelsey spoke mags, Weber carbs and Ram tubes, twin exhaust headers and mufflers, custom hood, custom front end with optional filler panel and custom taillights and rear bumper. All pieces still in plastic and connected to attaching ribs, includes original build instructions....

Open box 1/25 scale 1969 Cougar XR7 Street Machines model kit #6533-10E0 from the AMT ERTL company in Dyersville IA. Although the outer seal has been removed, all contents inside the box are sealed in their own individual packaging, unused. The tires are in a sandwich baggie, so someone was definitely in the box at one point. Includes detailed BOSS 429 engine with performance modifications, moveable steering wheel, vinyl tires and clear and plated parts. Decals include hood stripes...