My Lists
Login
Subtotal
$0.00
Shipping
Tax
Discount
Total
New LED dash light kit for the gauges in your STANDARD 67 - 68 Mercury Cougar. Finally, a kit that will provide you the...
As the seasoned Cougar owner will quickly point out, there are several differences between the 1967 and 1968 xr7 dash...
As the seasoned Cougar owner will quickly point out, there are several differences between the 1967 and 1968 Standard dash...
Reproduction gauge lens set for the 67-68 STANDARD Cougar. Includes Speedometer Lens, Temp/Amps/Oil/Fuel Lens and Clock...
Reproduction gauge lens set for the 67 XR7 Cougar. Includes Lenses for Speedometer, Tach, Amps/Volts, Temp and Oil...
New LED dash light kit for the gauges in your XR7 67 - 68 Mercury Cougar. Finally, a kit that will provide you the light...
This clip attaches by the driver's side front of the fuel tank opening, and holds the fuel line in place near the sending unit. Used on late 1967 to 1968 cars with the 3/8" fuel line. Early 1967...
Four required per car. *Tip from Andrew Petyak* Found a good product to clean used vacuum lines. Its called Wide White-from Coker tire (or Wesley's White Wall Bleach). Used to clean whitewall...
Good used clip used to route the wiring harness along the driver side of the engine compartment.Ford part number 382184-S.
Reproduction Lower Radiator Core Support Loom Clip for the 1967 - 1968 Mercury Cougar / 1967 - 1968 Ford Mustang
This trim clip is a little larger than the original C4GB-6242364-A retainer assembly Ford used and looks a little different, but will work just fine for the front extension mouldings. This will also...
This fragile little clip attaches to the bottom outer edge of the front fender extension and holds the tail of the aluminum eyebrow moulding to the extension, one per side. They almost always fail...
These retainer clips work for both the windshield and rear window stainless steel mouldings. These are often times rusty so when you are replacing your seal or trim be prepared to replace a few if...
These retainer clips work for both the windshield and rear window stainless steel mouldings. These are often times rusty so when you are replacing your seal or trim you may have to replace a few if...
This clip attaches the rear edge of the Xr7 overhead console to the support bracket. In 1968 the more common door panel clip was used for this application. The door panel clip can also be used for...
Known to have been used on 1969-1970 air conditioning boxes to hold a vacuum hose to the actuator. They can be screwed or bolted to the plenum. Used plastic clip for the Mercury Cougar or Ford...