Electrical & Lighting

These are also a good replacement bulb for the 67-68 under-dash courtesy lights as they are easier to grip than the 631 bulb.

Reproduction 158 Interior Auto Transmission Light Bulb for the 1967 and 1968 Mercury Cougar

Reproduction 1892 Interior Exterior Light Bulb for the 1967 - 1973 Mercury Cougar

Reproduction 1893 Interior Radio Light Bulb for the 1967 - 1973 Mercury Cougar

New 2.5 amp Buss style glass tube fuse for the Mercury Cougar or Ford Mustang. This fuse was used for 1967-68 only and is used for the instrument panel, clock and ashtray lights. This unit measure about 5/8" long and is Sold individually.

The second image shows an original GE 212-1 bulb. These bulbs are no longer available, they have been superseded by bulb 212-2 (first picture).

Replacement bulb for the door ajar warning light panel. This replacement bulb does not have the flashing feature like the OEM GE 256 installed bulbs. The original bulbs have a heat tab that flashes the bulb after a couple of seconds.

Concours correct Autolite spark plug wires for any 1967 Mercury Cougar or Ford Mustang with 289 engines and without smog pump. Black wires with 'Autolite' and 'radio resistance' imprinted on the 7mm wires. Correct black boots angled where needed.

Used 3 pin connector and light socket harness for the 1967-68 Mercury Cougar overhead console harness for seat belts and door ajar indicators. Blue and red light sockets. These are the same sockets for the seat belt reminder and door ajar warning lights on the ultra rare Safety Convenience Option offered in 1967-68 on both the Cougar and Mustang.

Used 4 pin connector and light socket harness for the 1967-68 Mercury Cougar overhead console harness for parking brake and low fuel indicators. Yellow and green light sockets. These are the same sockets for the parking brake and low fuel warning lights on the ultra rare Safety Convenience Option offered in 1967-68 on both the Cougar and Mustang.

Reproduction interior turn signal indicator 53x light bulb for the Mercury Cougar. *NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of information on the subject. ...

Reproduction 97 License Plate Light Bulb for the 1967 - 1973 Mercury Cougar

The Proper ignition advance curve is vital for maximum performance, economy (gas mileage) and drive-ability. Ford / Mercury owners had few acceptable choices with regard to adjusting the vacuum curve with their OEM distributor. You could fumble with the stock washers, fiber stops and springs (a hit-or-miss exercise in frustration!) or you could spend the money on an adjustable after market vacuum advance that looks completely out of place and cost you major judging points. This works on any...

Contains nut, lock washer, and spacer. Fits all Ford alternators.

Hard plastic terminal covers for the alternator. Replaces Ford Part #c7zz-14056-A

Nice reproduction of the original alternator wiring harness, has individual colored boots and wire colors match up to the original Ford drawings. Application is 1967 Mercury Cougar XR7 models or 1967 Ford Mustang with factory tachometer option, all with 390-4V engines. Ford service number C7ZZ-14305-C, original wire harness marked C7ZB-14305-C. *Caution, not for use with Cougar standard models or Mustang with alternator warning light.*Note - Excludes California models or cars with factory...

Reproduction alternator wiring harness for all 1967 Mercury Cougar Standard Models, meaning Non XR7. Additionally 1967 Ford Mustang with tachometer. Excellent reproduction copied from an NOS wiring harness.Ford service number C7ZZ-14305-E, wire harness marked C7ZB-14305-E.

Nice reproduction of the original alternator wiring harness, has individual colored boots and wire colors match up to the original Ford drawings. Application is 1967 Mercury Cougar standard models or 1967 Ford Mustang with factory tachometer option, all with S code 390-4V engines. Ford service part number C7ZZ-14305-D, original harness numbered C7ZB-14305-D. *Caution, not for use with Cougar XR7 models or Mustang with ammeter gauge. *Note - Excludes California models with Thermactor smog pump...

This is a 'made in China' wiring harness. Quality is OK and will work for this application. Application is 1967-68 Mercury Cougar XR7 models and Ford Mustang without factory tachometer option, all with 289 or 302 engines. *Caution, not for use with Cougar standard models or Mustang with alternator warning light. *Note - Excludes California models or cars with factory Thermactor smog pump with low mounted alternators.Replaces Ford Part # C7ZZ-14305-B Door Tag 65B

Nice reproduction of the original alternator wiring harness, has individually colored boots and the wire colors match up to the original Ford drawings. Application is 1967-68 Mercury Cougar XR7 models, all with 289 and 302 engines. Ford service number C7ZZ-14305-B, wire harness marked C7ZB-14305-B or C8WB-14305-C. *Caution, not for use with Cougar standard models. *Note - Excludes California models or cars with factory Thermactor smog pump with low mounted alternators ...

This is a replica of the warning tag that came on positive (+) terminal of Autolite batteries when the 1967 - 1972 Cougars and Mustangs were shipped from the factory.

This lens comes without the correct FoMoCo logo, sold individually. Replaces Ford Part # C5ZZ-15514.

These Back-Up Lamp Lenses are exact copies of the originals which come with the FoMoCo Logo. Sold Individually. Includes screws!

Sold individually. Stainless Steel

This kit is a time and money saver. Quality chrome bezels and all related parts are included. This is a direct plug-in, no modifications needed.

Hassle free kit makes it easy to install backup lamps. This kit includes mounting pads, lenses, gaskets, T1142 Bulbs and mounting hardware.

Great chrome on this reproduction backup / reverse light for the driver side (left hand) of the Mercury Cougar or Ford Mustang. Lens, gasket, and bulb sold separately. Replaces Ford part # C7ZZ-15512.

Great chrome on this reproduction backup / reverse light for the passenger side (right hand) of the the Mercury Cougar or Ford Mustang. Lens, gasket, and bulb sold separately. Replaces Ford part # C7ZZ-15511.

Reproduction backup light mounting spacers for the Mercury Cougar or Ford Mustang.

Plastic baffle for the instrument cluster on any 1967-68 Standard Model Mercury Cougar. This is for the AMPS light which is the right red light in the FUEL/TEMP gauge. There are a total of 6 of these plastic baffles for a 1967-68 Standard Model Cougar. This baffle is side specific, but resembles the OIL baffle. Ford part number C7WY-10A990-_ , exact suffix letter is unknown. *Note - will not work with an XR7 dash cluster

Plastic baffle for the instrument cluster on any 1967-68 XR7 Model Mercury Cougar. This is for the Brake system indicator bulb. There are a total of 1 of these plastic baffles for a 1967-68 XR7 Model Cougar, and it goes into the XR7 housing and shares space with the tachometer. Originally, these had a rubber seal on the lip. No more seals. Ford part number C7WY-10A990-_ , exact suffix letter is unknown. *Note - will not work with a Standard Model dash cluster. ...

Plastic baffle for the instrument cluster on any 1967-68 Standard Model Mercury Cougar. This is for the HiBeam indicator bulb. One of the  holes is not used. There are a total of 6 of these plastic baffles for a 1967-68 Standard Model Cougar. Ford part number C7WY-10A990-_ , exact suffix letter is unknown. *Note - will not work with an XR7 dash cluster

Plastic baffle for the instrument cluster on any 1967-68 Standard Model Mercury Cougar. This is for the left turn and brake system indicator bulbs. There are a total of 6 of these plastic baffles for a 1967-68 Standard Model Cougar. Similar to the right turn shroud, there is a locating nub that makes it different. Ford part number C7WY-10A990-_ , exact suffix letter is unknown. *Note - will not work with an XR7 dash cluster

Plastic baffle for the instrument cluster on any 1967-68 Standard Model Mercury Cougar. This is for the OIL light which is the left red light in the FUEL/TEMP gauge. There are a total of 6 of these plastic baffles for a 1967-68 Standard Model Cougar. This baffle is side specific, but resembles the AMPS baffle. Ford part number C7WY-10A990-_ , exact suffix letter is unknown. *Note - will not work with an XR7 dash cluster

Plastic baffle for the instrument cluster on any 1967-68 Standard Model Mercury Cougar. This is for the right turn and seat belt indicator bulbs. There are a total of 6 of these plastic baffles for a 1967-68 Standard Model Cougar. Similar to the left turn shroud, there is a locating nub that makes it different. Ford part number C7WY-10A990-_ , exact suffix letter is unknown. *Note - will not work with an XR7 dash cluster

Plastic baffle for the instrument cluster on any 1967-68 Standard Model Mercury Cougar. This is for the wiper switch. There are a total of 6 of these plastic baffles for a 1967-68 Standard Model Cougar. This baffle has a blacked out cone as shown. Ford part number C7WY-10A990-_ , exact suffix letter is unknown. *Note - will not work with an XR7 dash cluster

Each of these great kits include all three required cables, including part numbers, proper terminal and post clamp ends. Starter cables are properly shielded from heat. Standard Draw pictured above, High Draw pictured to the left. The originals were either 43-55 Amp (Standard) Draw or 65-70 Amp (High) Draw. We recommend going with the High Draw. As one customer put it, "These [standard draw cables] look anemic." (Thanks for the feedback Charles!) Replaces Ford Part # : C7ZZ-14300 ...

Each of these great OEM Style kits include all three required cables, proper terminal and post clamp ends. Unlike CONCOURS CORRECT cables, these do not have the Ford part numbers on them. Starter cables are properly shielded from heat. The originals were either 43-55 Amp (Standard) Draw or 65-70 Amp (High) Draw. We recommend going with the High Draw. As one customer put it, "These [standard draw cables] look anemic." (Thanks for the feedback Charles!) NOTE: These cables are technically correct...

No more crust, white powdery battery terminals. Just spray this stuff on, and after a few minutes....simply wash off with water! Not only can you use this stuff on your car, you can use it on your ATV's, quads, dirt bikes and even your ride on lawnmower! A handy item to have laying around your garage. Of course, there's a little more messy, mostly free alternative which you can find the ingredients for online, but why bother? This is a simple, fairly cheap product to have.  

This battery cover is designed to be used with any maintenance free flat top battery **24/60 series with original terminal location for the Autolite battery covers.

Reproduction "Battery OK" Decal for the 1967 - 1982 Mercury Cougar / Ford Mustang

Perfect fit the first time. You will be happy with this Group 24, quality reproduction and check out the price! These battery trays are a popular item for restorers since most of the originals have been destroyed by leaking batteries over the years. Replaces Ford part #: C7ZZ-10732-D.

Concourse correct with 22 & 24 series batteries for Mustang, Cougar and Shelby GT350/500 made in the USA by Mansfield Mustang to orig. Ford Specs includes attaching bolts Replaces Ford Part # C7ZZ-16060-A

Used in 1967 - 1968 standard model Cougars without the optional clock. Usually these will have some amount of fading or minor discoloration in the paint as we keep the mint ones to build tachometers from.Check out the video below on our new gauge tester: ...

Kit comes complete with J bolts and mounting nuts. Replaces Ford Part #: D0AZ-10756-K.

Fastens the battery tray to the fender apron.

Billet aluminum batter hold down bracket for all 1967-70 Mercury Cougar and Ford Mustangs. Maximum battery width 6-3/4 inches. We also have stainless steel hold down bolts available.

These courtesy light brackets are located on the very outer right and left under the dash. Typically this bracket is found on the passenger side of 1967-68 Mercury Cougar and Ford Mustang without air conditioning. This is the long style bracket. There is also a short style for both the driver and passenger side courtesy light. If you have factory air conditioning you would want the short bracket that doesn't come into contact with the A/C plenum.Replaces Ford part number C7ZB-13763-A.Fits:1967...