My Lists
Login
Subtotal
$0.00
Shipping
Tax
Discount
Total
New LED dash light kit for the gauges in your STANDARD 67 - 68 Mercury Cougar. Finally, a kit that will provide you the...
This listing is for the person who only has rust under the lip at the front and does not want to pay shipping on an entire...
Reproduction 3D printed retainer / friction clip that replaces broken injected plastic shaft retainers on fixed or tilt...
When ordering this item, you do not need to order a key blank, the key is included. If you need more than one key, you don't...
Premium reproduction rear valance for the 67 - 68 Cougar. This valance is a direct fit, as opposed to our economy version...
Reproduction plastic plate that goes between the dash bezel and dash pad on any 1967-68 Standard model Mercury Cougar with...
Reproduction A/C center vent for XR7 (non Standard) model Cougars. These are great quality vents with bright chrome...
Reproduction A/C center vent for standard (non XR7) model Cougars. These are great quality vents with bright chrome finish....
These bulbs work with Cougar factory spec turn signal flashers, but they may not work with all aftermarket flashers,...
Pair of reproduction headlight actuators for the 67 - 68 Mercury Cougar. Manufactured to meet and exceed factory specs...
Economy reproduction aluminum rear deck lid moulding / trim for the 1967 - 1968 Mercury Cougar (will also fit on 1969-1970)....
Used wiring pigtail that runs from the under hood harness to the starter solenoid (battery side post) on the 67 - 68 Standard and XR7 model Cougars.
Used wiring harness that runs from the 14290 under hood harness to the voltage regulator on the 67 - 68 XR7 Cougar.
New old stock manual steering worm gear for any 1967-70 Mercury Cougar or Ford Mustang with manual steering or 19:1 steering gear box. Factory new worm gear assembly for rebuilding your steering...
Used wrench or crank, for manually closing the factory installed sunroof installed on any 1967-73 Mercury Cougar. Sunroofs, technically moonroofs, were originally installed by ASC or American...
Quality plexi-glass lens that is ready to install. Just peel off the protective tape and carefully pull your clock apart and replace and reassemble.The originals had a very slight concavity to them...