Contact Us / Visit Us (click here)
CANADIAN CUSTOMER: Due to the Canada Postal Service strike, we recommend choosing DHL Express.
Note: UPS Mail Innovations is delivered by the post office and Canadian deliveries will be affected by the strike.
International Customers Click Here [Updated 6/2024]
 
Refine Search:

Search This Category:
Select layout:
Products (Click sub-categories above to ONLY display results for that Sub-Category) 2593-2640 of 5073
$0 Price: $0.98

Buy Details

Availability: In-Stock Item
Item #: 33726 -

Locking nut that attaches the shift lever to the shifter arm and support inside the shifter buckets. We normally see the fine threaded nuts on the 1967-70 shifters. Please check your shift arm support for correct threads.  3/8-24 threaded nut, serrated washer head style. Check out our video on rebuilding your shifter below: ...

$0 Price: $1.89

Buy Details

Availability: Used / Wrecking Yard Item
Item #: 10470 -

Locking nut that attaches the shift lever to the shifter arm and support inside the shifter buckets. We normally see the fine threaded nuts on the 1967-70 shifters. Please check your shift arm support for correct threads. Check out our video on rebuilding your shifter below: ...

MSRP:$19.99
$19.99 Price: $15.89

Buy Details

Availability: Discontinued, Limited Stock on Hand
Item #: 41861 -

This is a 100% accurate reproduction down to the captured lock washer and black Zinc coating. The only difference is that these are made from a substantially better grade of steel than the originals. These often break when you try to remove them to replace the vacuum actuator so if you are planning on doing that procedure we highly recommend buying these in conjunction with the actuators. Sold individually, two required per car. Cougar part number C7SZ-13A173-A. Also Fits: 1967 Ford...

$0 Price: $12.87

Buy Details

Availability: Used / Wrecking Yard Item
Item #: 20513 -

This is the bolt that often gets destroyed when you try to remove it from the bottom side of the headlight bucket. Our West Coast Cougars come apart a little easier so we often are able to pull them with minimal effort. Cougar part number C7SZ-13A173-A. Application includes: 1967-68 Mercury Cougar and XR7, 1967-68 Ford Thunderbird, 1969-71 Lincoln Continental MK III. Do you want to replace those worn out actuators yourself or are you looking for some great information on aligning the grille in...

$0 Price: $8.87

Buy Details

Availability: In-Stock Item
Item #: 11-4002 -

Used mounting plate for the heater blower motor on the 67 - 68 Cougar or Mustang without A/C.

$0 Price: $5.00

Buy Details

Availability: In-Stock Item
Item #: 14207 -

4" mounting Plate for Standard Spare Tire. Replaces Ford Part #: C5ZZ-1424-A.

$0 Price: $0.29

Buy Details

Availability: In-Stock Item
Item #: 26135 -

Attaching screws for the headlamp adjusting screws for the 1967-70 Mercury Cougar and most other Ford and Mercury cars and trucks. Each of the headlamp adjusting screws uses 2 of these screws. A Cougar with 4 headlights would need a total of 16 of these screws.

$0 Price: $1.89

Buy Details

Availability: Used / Wrecking Yard Item
Item #: 15-0017 -

Unique shouldered screw that keeps your switch in perfect alignment, using incorrect screws will damage the switch.Fixed columns require 3 screws. Tilt columns require 2 screws.  *NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of...

$0 Price: $3.59

Buy Details

Availability: In-Stock Item
Item #: 33216 -

Set of 16 attaching screws for the headlamp adjusting screws for the 1967-70 Mercury Cougar and most other Ford and Mercury cars and trucks. Each of the headlamp adjusting screws uses 2 of these screws. A Cougar with 4 headlights would need a total of 16 of these screws.

$0 Price: $0.85

Buy Details

Availability: In-Stock Item
Item #: 41179 -

Fits 1967 Standard and XR7 Cougars or most Ford and Mercury with inside rear view mirrors. Also used on the 1967 xr7 hash marks located on the rocker.

$0 Price: $12.87

Buy Details

Availability: Out of Stock
Item #: 20314 -

These spacers are required to properly mount the trunk lock housing to the trunk. Two required per car, sold individually. Ford part number C7WY-6543565-A. Check out this video

$0 Price: $16.85

Buy Details

Availability: In-Stock Item
Item #: 31769 -

These spacers are required to properly mount the trunk lock housing to the trunk lid.  Sold as a pair. Replaces Ford part number C7WY-6543565-A. Follow this link to find the lock housing nuts. Check out this video

$0 Price: $0.81

Buy Details

Availability: In-Stock Item
Item #: 41256 -

1/4-20x1 inch stud. Sold individually. Found on various years and parts of Cougars. Used for attaching 1967-68 grilles to the headlight buckets. Also as replacement mounting studs for front and rear fender and quarter extensions. Zinc Dichromate (yellow-rainbow)

$0 Price: $45.55

Buy Details

Availability: In-Stock Item
Item #: 41344 -

This is one of the best small block Ford V-8 books on the market. It covers 260-289-302 V8 engines. Carburetor numbers, distributor numbers, covers all engine brackets, pulleys, and parts of Ford small block engines. 100's of pages with pictures, casting numbers, and explanations by year. A must for concours detailing and year by year correctness. Author Bob Mannel, covers small block V8 engines and components 1962-69. References all Ford cars that these engines came in. Mustang, Cougar,...

$0 Price: $0.95

Buy Details

Availability: Discontinued, Limited Stock on Hand
Item #: 41744 -

Bumper bolt nuts sold individually. Also available in our bumper bolt kit.Please know that chrome cracking from the installation of bumper bolts on our rechromed bumpers is not covered under warranty. We have observed that some reproduction wavy washers are of a thicker material than original and require more torque to flatten out properly for a good fit. We suggest that no matter what thickness your repro wavy washer is that you flatten them out in a vise prior to installation so as not to...

$0 Price: $1.89

Buy Details

Availability: Used / Wrecking Yard Item
Item #: 11-0427 -

Special nut with large diameter spinning washer for the set screw for the door glass adjustment. Sets and holds your door glass angle to allow a proper seal. Three set screws work in conjunction for each door glass and vent window combination. See your shop manual for actual procedure.See also 378696-S for the vent window and front door channel set screws.Ford part number 33797-S.

$0 Price: $3.65

Buy Details

Availability: In-Stock Item
Item #: 41041 -

Reproduction nut that replaces Ford part # 34033-S. This is the nut that secures the pitman arm to the steering box. Has correct 7/8"-14 threads. Split washer also needed, not included, nut only.

$0 Price: $1.85

Buy Details

Availability: In-Stock Item
Item #: 41338 -

Four nuts per bucket seat, 8 total nuts per car with bucket seats. Sold individually. Replaces Ford part # 378643-S. Phosphate & Oil (gray & black) finish

$0 Price: $2.88

Buy Details

Availability: Used / Wrecking Yard Item
Item #: 20179 -

Unlike our reproduction nuts these good used original nuts can be purchased individually and they cost less to boot! 8 required per car, 4 per bucket seat.

$0 Price: $0.85

Buy Details

Availability: In-Stock Item
Item #: 27481 -

New 3/8-16 nut for the shock tower shock cap. Three nuts used on each cap, 6 total per car. Sold individually.Replaces Ford part number 377706-S7.

$0 Price: $3.35

Buy Details

Availability: In-Stock Item
Item #: 31094 -

Nut for attaching the steering wheel on any 1967 Mercury Cougar or 1965-67 Ford Mustang.Ford number 350983-S.

$0 Price: $0.45

Buy Details

Availability: Used / Wrecking Yard Item
Item #: 19481 -

These were used to attach the taillight assembly to the tail panel on a 1969-70 Cougar. Five were used per taillight, 10 required in all for one car. Sold individually. Also the same size for 1967-68 tail lights.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a...

$0 Price: $0.85

Buy Details

Availability: In-Stock Item
Item #: 22997 -

These are the little 11/32" lock nuts (sometimes called speed nuts) that you use to attach the taillight bezel to the taillight housing. 10 nuts per bezel, 20 per car.

$0 Price: $6.89

Buy Details

Availability: Used / Wrecking Yard Item
Item #: 24092 -

C7WB-13753-A Grade-A used screw on nut or bezel for the dash toggle switches on 1967-68 Mercury Cougar XR-7, 1971-73 Mercury Cougar, and 1969-70 Mustang Shelby console switches. This is a perfect used part, if you need an average quality used one mention it when you make your order and we will try and locate a free one for you.

$0 Price: $0.90

Buy Details

Availability: In-Stock Item
Item #: 31243 -

New torque converter nuts for connecting torque converters to flex plates on 1967-73 Mercury Cougar or 1967-73 Ford Mustang or other Ford Lincoln Mercury that is not metric. 3/8-24 threads, Grade 8 nut with a 9/16 inch hex. 0.79" OD and 0.39" thick. Torque converters use 4 nuts for attachment.Ford number 377704-S

$0 Price: $0.59

Buy Details

Availability: Used / Wrecking Yard Item
Item #: 11-0144 -

34392-S7 5/16 inch nut for 1967-68 Mercury Cougar and Ford Mustang vent window pivot assembly. 1 per side.

$0 Price: $20.65

Buy Details

Availability: In-Stock Item
Item #: 26128 -

Quality chrome and fit. Replaces Ford Part #: C7ZZ-11650-A. Here is a helpful youtube video on how to go about removing a headlight switch from a Cougar or Mustang. 

$40.85 Price: $40.85

Buy Details

Availability: Rare / NOS Part
Item #: 32945 -

Nut and ferrule assembly for thermactor smog tubes. Sold individually, 8 per car with V-8 engine. This is a NOS replacement nut and ferrule that is one piece. Fits thermactor equipped cars from 1967-71. Including 1967 cars with California emissions, 1968 manual transmission cars, 1968-71 Ford cars with factory Holley carburetors, etc. Several Ford part numbers for this item C7AZ-9B471-A, AND D5TZ-9B471-A, C6AZ-9B471-A,C8OZ-9B471-A.

$0 Price: $37.67

Buy Details

Availability: Rare / NOS Part
Item #: 32303 -

Nut and ferrule assembly for thermactor smog tubes. Sold individually, 8 per car with V-8 engine. This is a NOS service replacement nut and ferrule that is one piece. Fits thermactor equipped cars from 1967-71. Including 1967 cars with California emissions, 1968 manual transmission cars, 1968-71 Ford cars with factory Holley carburetors, etc. Several Ford part numbers for this item D5TZ-9B471-A, C6AZ-9B471-A,C8OZ-9B471-A.

$0 Price: $2.55

Buy Details

Availability: In-Stock Item
Item #: 32097 -

Reproduction pair of snap nuts for attaching the hood latch support to the hood latch on the 67 - 68 Cougar. 

$0 Price: $1.45

Buy Details

Availability: Used / Wrecking Yard Item
Item #: 33305 -

These nuts and little red insulators are needed when installing the factory Amp gauge. Sold as a pair (2 nuts and 2 insulators). 

$0 Price: $19.62

Buy Details

Availability: In-Stock Item
Item #: 31554 -

Nuts and washers for attaching the rear differential carrier or pumkin or third member to the rear axle housing.Correct for all 1967-68 Mercury Cougar and 1965-68 Ford Mustang. 8 inch or 9 inch third members, all the same.

$0 Price: $0.85

Buy Details

Availability: In-Stock Item
Item #: 27468 -

New plastic nut or insert for those 1/4 inch square holes in the grille for attaching the headlight doors (8 required there), and for the XR7 door pull panel mounting plates for attaching the actual door handles (2 required per side). Replaces Ford part # 379830-S1. Check out this video ...

$0 Price: $0.85

Buy Details

Availability: In-Stock Item
Item #: 27469 -

Correct size and style white square plastic insert that clips onto front or rear license plate bracket on any 1967-73 Mercury Cougar. Each kit allows one license plate to be mounted. The actual screw has a large head which is made for license plates, but is not the factory Ford style of fastener for Concours judged cars. We also sell an accepted original style of screw, see item 8286.