My Lists
Login
Subtotal
$0.00
Shipping
Tax
Discount
Total
NEW PRODUCT! This gauge tester can be used to test all gauges on any Ford vehicle from 1956 to 1983. We are...
Must have for 69-70 convertible owners or anyone else who wishes to tighten up the notoriously weak front inner structure of...
Reproduction 3D printed retainer / friction clip that replaces broken injected plastic shaft retainers on fixed or tilt...
When ordering this item, you do not need to order a key blank, the key is included. If you need more than one key, you don't...
As seen on Gearz with Stacey David. If you're looking for the best and brightest lighting for your car, look no further....
Reproduction Two Spoke Steering Wheel Pad for the 1968 Mercury Cougar Check out our video review...
Reproduction 7-blade fan, fan clutch, fan to clutch bolt kit, and water pump to clutch bolt kit for the 67 - 70 Cougar...
Reproduction rearview mirror lens for the Late 68 - 73 Cougar or Mustang. This lens is slightly smaller than the original,...
This cart was used by service stations or garages to provide jump starting services to vehicles with dead batteries. The...
This rack was used by service stations or garages to hold oil cans / parts for sale. The design and style suggests that it...
T5 TRANSMISSION INFORMATIONFor any and all questions or technical support for this transmission or its installation,...
New Old Stock rubber hood bumper. Fits all 1967-68 Mercury Cougar and Ford Mustang including Shelby GT-350 and GT-500. Replaces Ford part #: C7WY-16758-A.
These Radiator Hood Support Bumpers reproductions are sold as a pair. They fit the 67, 68, 69, 70, 71, 72, and 73 Mercury Cougar. Replaces Ford part #: C5ZZ-16763.
These stainless steel radiator hood support bumper reproductions are sold as a pair. They fit the 67, 68, 69, 70, 71, 72, and 73 Mercury Cougar. Replaces Ford part #: C5ZZ-16763.
Bushing that goes to the inside of the brake booster pushrod. This is the early version of this part that is made of plastic, a later version was introduced in 1969 which was made of nylon and...
Reproduction bushing for the master cylinder push rod where the switch and brake pedal converge. Two required per car and the bushings are sold separately.Ford part number C5DZ-2B129-B
Replacement tail shaft bushing, for all 1964-73 C4 transmissions.
Replacement tail shaft bushing, for all 1969-73 FMX and 1967-73 C6 transmissions.
This is the bushing that Ford lists as the REAR stabilizer end link bushing, but it works for both front and rear. Smaller image shows a comparison of the NOS(Left) and Repro (right). SOLD...
Replacement rubber bushing for repairing any automatic shift arms on any 1967-73 Mercury Cougar or Ford Mustang, and most Fords with automatic floor shift levers. Fits arms with 3/4 inch lower holes...
Although this premium reproduction strut rod bushing kit appears very similar to the economy kit, they are in fact superior. The main difference being that the bushings are made from a higher...
These reproduction brake and clutch pedal bushings are made from high strength plastic that is wear resistant. Two are required for automatic cars, four for manual transmission cars. Sold as a pair....
Reproduction pair of brass 3/8 ID bushings for the clutch rod. Protects clutch equalizer and rod, and removes excess play.We also sell these in nylon. Replaces Ford Part #: C0AZ-7526-B. Customer...