My Lists
Login
Subtotal
$0.00
Shipping
Tax
Discount
Total
NEW PRODUCT! This gauge tester can be used to test all gauges on any Ford vehicle from 1956 to 1983. We are...
Must have for 69-70 convertible owners or anyone else who wishes to tighten up the notoriously weak front inner structure of...
Reproduction 3D printed retainer / friction clip that replaces broken injected plastic shaft retainers on fixed or tilt...
When ordering this item, you do not need to order a key blank, the key is included. If you need more than one key, you don't...
As seen on Gearz with Stacey David. If you're looking for the best and brightest lighting for your car, look no further....
Reproduction Two Spoke Steering Wheel Pad for the 1968 Mercury Cougar Check out our video review...
Reproduction 7-blade fan, fan clutch, fan to clutch bolt kit, and water pump to clutch bolt kit for the 67 - 70 Cougar...
Reproduction rearview mirror lens for the Late 68 - 73 Cougar or Mustang. This lens is slightly smaller than the original,...
This cart was used by service stations or garages to provide jump starting services to vehicles with dead batteries. The...
This rack was used by service stations or garages to hold oil cans / parts for sale. The design and style suggests that it...
T5 TRANSMISSION INFORMATION For any and all questions or technical support for this transmission or its installation,...
Reproduction 3D printed retainer / friction clip that replaces broken injected plastic shaft retainers on fixed or tilt steering collapsible columns on most FoMoCo products starting in 1968 and...
Reproduction heater resistor attaching pins correct for 1967-68 Mercury Cougar and Ford Mustang, but works fine with 1969-73 cars too. Sold in sets of 2 pins.
Used retaining bolt with nut for the fixed column on any 1967 - 68 Mercury Cougar or 1965-68 Ford Mustang. 2 of these bolts are required to holt the two sections of the upper column sleeves...
Spring steel clip located under the drive cable housing as seen on page 16, figure 19 of our free download of the sunroof panel service procedure manual. ...
Used grade A side mirror retaining nut for the 1968 Mercury Couga or Ford Mustang. Grade A's will have no scratches or dings.Ford part number C8ZZ-17B719-A
Used grade A side mirror retaining nut for the 1968 Mercury Couga or Ford Mustang. Grade B's will have minor scratches or dings. Ford part number C8ZZ-17B719-A
Replaces the original Ford part that features a # C7SB-17B732-A casting number. Basically correct for 1967 but works just as well on 1968 mirrors. These nuts are are not 100% correct for a 67 or 68,...
This fits behind the door panel and is needed to install your remote mirror correctly.*NOTE*1969 Cougar owners do not need this part as it is built in the the chromed plastic, rectangular bezel on...
Replaces Ford part #C0AZ-9A307-B.
Good used ring with only surface rust and no obvious gouges.
Used retaining ring for the fuel sending unit or vent on 1971 and newer tanks. Fits a little tighter than the reproduction rings. Ford part #C0AZ-9A307-B.
Used retaining spring and two screws for attaching the break away air conditioning vents to any 1968 Mercury Cougar or Ford Mustang with factory installed A/C.