My Lists
Login
Subtotal
$0.00
Shipping
Tax
Discount
Total
NEW PRODUCT! This gauge tester can be used to test all gauges on any Ford vehicle from 1956 to 1983. We are...
Must have for 69-70 convertible owners or anyone else who wishes to tighten up the notoriously weak front inner structure of...
Reproduction 3D printed retainer / friction clip that replaces broken injected plastic shaft retainers on fixed or tilt...
When ordering this item, you do not need to order a key blank, the key is included. If you need more than one key, you don't...
As seen on Gearz with Stacey David. If you're looking for the best and brightest lighting for your car, look no further....
Reproduction 7-blade fan, fan clutch, fan to clutch bolt kit, and water pump to clutch bolt kit for the 67 - 70 Cougar...
Reproduction rearview mirror lens for the Late 68 - 73 Cougar or Mustang. This lens is slightly smaller than the original,...
This cart was used by service stations or garages to provide jump starting services to vehicles with dead batteries. The...
This rack was used by service stations or garages to hold oil cans / parts for sale. The design and style suggests that it...
T5 TRANSMISSION INFORMATIONFor any and all questions or technical support for this transmission or its installation,...
This kit is the same Scott Drake "Shelby Style" hood pin kit offered by many other vendors.Kit includes 2 Hood Pins, 2 dowel pins, 4 Nuts to hold the dowel pins on, plates for the top of the hood, 8...
* - This scoop can be used for 1969 - 1970 Cougar Eliminators and many other Ford models that had similar scoops. This is not the correct scoop for the 1969 - 1970 Cougar Eliminators, but it is the...
This average quality offshore reproduction scoop was never offered on a Cougar but looks good and fits well on the Cat. Will not line up with factory holes in a Cougar hood. Replaces Ford Part #:...
Welded in hooked retainer for the rear seat back installation on any 1967-73 Mercury Cougar or Ford Mustang coupe or hard top body style. This bracket welds to the edge of the package tray. Two...
This item has been discontinued until further notice. Basically correct looking except for screws in place of the rivets. The High or Low tone is indicated in raised letters located on the perimeter...
This item has been discontinued until further notice. The High tone is indicated in raised letters located on the perimeter of the horn. We do offer the correct used Cougar horns.Replaces Ford Part...
This item has been discontinued until further notice.The Low tone is indicated in raised letters located on the perimeter of the horn. We do offer the correct used Cougar horns.Replaces Ford Part #...
Attaches behind the drivers side horn on all 1969-70 Mercury Cougar and Ford Mustangs with air conditioning. We believe that this part was installed to maintain clearance with the A/C condenser....
Wire extension for horn relocation, when the drag pak or drag pack option was ordered typically with 3.91 or 4.30 rear axle ratio. Fits all 1969-70 Mercury Cougar or Ford Mustang with factory oil...
NOTE: A FEW CUSTOMERS HAVE MENTIONED THAT THE INSTRUCTIONS MAY BE WRONG. SWITCHING PINS 1 AND 5 HAD A BETTER RESULT. IF YOU RECEIVE THIS PART AND ARE HAVING TROUBLE WITH THE INCLUDED INSTRUCTIONS,...
Tested and working used pair of Hi and Lo tone horns. 1969-70 Mercury Cougar and Ford Mustang used part number C9ZF-13802-C and C9ZF-13801-B. Every horn is bench tested and inspected for cosmetic...
Black paper wrapped aluminum flexible tube that connects the vapor canister to the air cleaner. This is as close to concours as we can find, 3/4 inch diameter, 36 inches long, and black outside,...