My Lists
Login
Subtotal
$0.00
Shipping
Tax
Discount
Total
Reproduction rear courtesy / opera light lenses for the Mercury Cougar. The rear courtesy / opera lights were standard...
New LED dash light kit for the gauges in your Mercury Cougar. Finally, a kit that will provide you the light you need to...
NEW PRODUCT! This gauge tester can be used to test all gauges on any Ford vehicle from 1956 to 1983. We are...
As seen on Gearz with Stacey David. If you're looking for the best and brightest lighting for your car, look no further....
This wiring harness has an included lamp socket that plugs into your instrument cluster just below your right turn signal light.This 1967 harness attaches to the ignition switch, and the seat belt...
Power wire that connects the PRNDL or shift indicator illumination lamp assembly, and the main under dash wiring harness on all 1967 Standard Cougars and Mustangs. All electrical harnesses are...
Used wiring pigtail that runs from the under hood harness at the kick panel to the starter solenoid / horn / voltage regulator on the 67 - 68 Cougar.
Emergency or parking brake indicator lamp and wiring harness. Tested and working red indicator light which was found optionally on any 1967 Mercury Cougar standard model 65A or 65C. The 1967 parking...
This is the power feed harness that the main console wiring harness C7ZB-13B711-A plugs into, this harness runs under the carpeting to the shifter opening. We offer the main console harness and the...
Used radio light socket and wiring pigtail for all factory Philco AM radios as installed in 1967-70 Mercury Cougar and Ford Mustang cars. These light sockets are tested and cleaned, and have enough...
Original used AM radio speaker lead wiring harness pigtail for all 1967-70 Mercury Cougar and Ford Mustangs with factory AM radios. We have a limited supply of these but also offer a quality...
Original used speaker lead wiring harness pigtail for all 67 - 68 Cougars and Mustangs with factory AM radios. This wire pigtail is located in the kick panel.*Note - The only difference between this...
Used pigtail that runs from the main 14401 harness to the brake light circuit breaker. Works on both standard and XR7.
Used wiring pigtail that runs from the 14401 main harness to the brake light circuit breaker. This pigtail actually feeds the brake switch. Works on both standard and XR7.
Used pigtail that runs from the 14401 harness to either the driver or passenger side door harness for the door ajar.
Used pigtail that runs from the main 14401 harness to the driver side door jamb switch.