1967 Mercury Cougar

Reproduction Dash to Engine Gauge Feed with push-on Post Oil Sender for the 1967 and 1968 Mercury Cougar with the 289 or 302. Red / Green stripe wire = Coil White / Red stripe wire  = Temp Red / White stripe wire = Oil lamp * Note - Verify your oil pressure switch has the connector to accept the push on boot plug. Replaces Ford Part #: C6DZ-14289-BCheck out the video below on our new gauge tester: ...

Reproduction Dash to Engine Gauge Feed with Tach and Slide-on clip Oil Sender for the 1967 and 1968 Mercury Cougar with the 289 or 302. * Note - Check the style of oil pressure connector on your engine. Replaces Ford Part #: C7DZ-14289-BCheck out the video below on our new gauge tester: ...

Reproduction Dash to Engine Gauge Feed Harness with the push-on post oil sender for the 1967 and 1968 Mercury Cougar or Mustang with the 390, 427 or 428 Big Block. Replaces Ford Part #: C7ZZ-14289-ACheck out the video below on our new gauge tester: ...

Anti rattle spring for the 1967 Cougar and Mustang clutch release lever spring. Ford part number C6AZ-7562-A.

Used wire extension for the tilt / tilt away steering column found in the Mercury Cougar or ford Mustang. *NOTE* WCCC services all FoMoCo tilt and tilt-tilt away steering columns 1967-1979. Our shop rate for this service is $90 per hour and most columns with serious problems do need complete tear down and build up which usually takes 3-4 hours plus the cost of any replacement parts needed. To offset the cost of your rebuild, you can send us additional parts or parts columns and we will give...

Air Conditioning Clutch Feed Wire that runs along the driver side valve cover to the clutch on the compressor. About 24 inches in total length. Starting in 1969 the female plug was of the water proof variety. Black plugs on either end.

Air Conditioning Clutch Feed Wire that runs along the driver side valve cover to the clutch on the compressor. About 24 inches in total length. Starting in 1969 the female plug was of the water proof variety. Black plugs on either end.Replaces Ford Part #: C9ZB-19A885-B.

Reproduction console feed harness for the 67 - 68 Cougar or Mustang. This OEM direct fit wiring harness supplies power from the under dash harness to the console harness.

Complete 25 piece clip kit for the 1967 Cougar or Mustang. Keep in mind that this is produced as a Mustang clip kit, and although most clips are the same between Mustang and Cougar...not all clips apply to Cougar applications.   

This Screw fastens the plastic guide for turn signal wires next to column under the cone by steering wheel.

Used grade "A" simulated wire spoke hubcap / wheel cover that is in excellent condition with no curb scrapes. This listing is for someone who has removed their center from their current damaged cap and wants to save money by purchasing a cap with no center. The same cap was used on Most all FoMoCo products including but not limited to the Falcon, Mustang, Fairlane, Comet, Galaxie, Montego and LTD, only the center logo changed one car to the next. Ford part # C7WY-1130-C. *NOTE* You will often...

Used black plastic clip for holding the turn signal wiring harness to the column tube, next to the vacuum actuator. Fits any 1967 Mercury Cougar or Ford Mustang with tilt swing away steering columns.

Master clip kit which includes the following fasteners:Engine bayEngine feedFirewallFront crossmemberParking lightsPassenger side apron below relayRadio cable to dashKeep in mind that not all fasteners found on 1967 Courgars / Mustangs are in this kit.

Under dash wiring harness assembly for all 1967 Mercury Cougar and Ford Mustangs with integral, or factory installed air conditioning. All wiring harnesses are test and inspected by our electrical department.Replaces Ford part number C7ZB-19945-A.

New console wiring harness for 1967-68 Standard Cougar any all 1967-68 Ford Mustang. This harness is for the light in the roll up garage door compartment and the rear console lights. There is a jumper wiring harness also available, that connects to the main under dash harness. See related items. Ford part number C7ZB-13B711-A. *Note - Not for Mercury Cougar XR7 models.

Reproduction console wiring harness for 1967-68 Standard Cougar any all Mustang. This harness is for the light in the roll up garage door compartment and the rear console lights. There is a jumper wiring harness also available, that connects to the main under dash harness. See related items. Replaces Ford part number C7ZB-13B711-A. *Note - Not for Mercury Cougar XR7 models.

Console wiring harness for 1967-68 Standard Cougar any all Mustang. This harness is for the light in the roll up garage door compartment and the rear console lights. There is a jumper wiring harness also available, that connects to the main under dash harness. See related items. Ford part number C7ZB-13B711-A. *Note - Not for Mercury Cougar XR7 models.

This the light connector harness for the dash convenience panel that connects to the door harness (door ajar) and low fuel harness. Fits both 1967 and 1968 Mercury Cougar and Ford Mustang. Has low fuel lead for Cougar on driver side, plug for low fuel on passenger side for Mustang. One plug is unused, depending upon application. This is a rare option, indicator lights would be installed in the center section of the dash panel. Unless, air conditioning was installed. If the car...

This the main under dash harness for the convenience panel that connects to the door harness (door ajar) and low fuel harness. Fits 1967 Mercury Cougar and Ford Mustang. Has low fuel lead for Cougar on driver side, plug for low fuel on passenger side for Mustang. One plug is unused, depending upon application. This is a rare option, indicator lights would be installed in the center section of the dash panel. Unless, air conditioning was installed. If the car had factory A/C and the...

Wiring harness for the low fuel sending units on 1967 Mercury Cougar XR7 and standard models with low fuel warning light. The Safety Convenience Option included a low fuel warning light. This harness has two wires which attach to the three prongs on the 1967 C7ZF-9275-D low fuel sending units.1967 and 1968 will interchange, 1967 has a plastic shielding on the end of the wire loom that is under the car. 1968 version does not have this shielding. We suspect that the Ford part number is...

Used lower wiring harness for the overhead console on the 67 Cougar XR7. Sometimes known as the Convenience Group Harness. This harness runs down the C pillar, under the door scuff plates and exits on the passenger side under the dash. That's where it connects to the under dash wiring harness. The upper harness runs from the overhead console, under the headliner and back to the C pillar where it connects to this lower harness. You can get the upper harness here. Ford Part Number C7WB-10C877-C ...

Used upper wiring harness for the overhead console on the 67 - 68 Cougar XR7. Sometimes known as the Convenience Group Harness. This harness runs under the headliner from the overhead console back to the C pillar, where it connects to the lower harness. You can get the lower harness here. Ford Part Number C7WB-10C877-F

Used grade A standard 14405 harness is inspected, professionally repaired, tested, and ready to install. This harness connects to the main 14401 under dash harness at the passenger side door jamb, and runs through to the trunk. It connects to the sequential unit and the fuel sending unit.These grade "A" harnesses will be uncut and unburnt. This is for those of you who demand excellent original parts for your Cougar.

Used grade B standard 14405 harness is inspected, professionally repaired, tested, and ready to install. This harness connects to the main 14401 under dash harness at the passenger side door jamb, and runs through to the trunk. It connects to the sequential unit and the fuel sending unit. Grade "B" harnesses may have one or two repairs where the grade "A" harnesses will be rare uncut and unburnt beauties.

Used grade A standard 14405 harness is inspected, professionally repaired, tested, and ready to install. This harness connects to the main 14401 under dash harness at the passenger side door jamb, and runs through to the trunk. It connects to the sequential unit and the fuel sending unit.  NOTE: The 1967 harness does not include the overhead harness wiring. These grade "A" harnesses will be uncut and unburnt. This is for those of you who demand excellent original parts for your Cougar. ...

Used XR7 14405 harness is inspected, professionally repaired (if needed), tested, and ready to install. This harness connects to the main 14401 under dash harness at the passenger side door jamb, and runs through to the trunk. It connects to the sequential unit and the fuel sending unit, and also connects to the overhead console. Ford part number C8W8-14405-F

Used tilt column wiring harness for the 1967 Mercury Cougar. 

This wiring harness has an included lamp socket that plugs into your instrument cluster just below your right turn signal light.This 1967 harness attaches to the ignition switch, and the seat belt reminder relay (sold separately). Tested harness includes 1895 bulb, 7-1/2 amp fuse.

Power wire that connects the PRNDL or shift indicator illumination lamp assembly, and the main under dash wiring harness on all 1967 Standard Cougars and Mustangs. All electrical harnesses are inspected, professionally repaired (when needed), tested, and ready to install. Harness marked C7ZZ-15A808-A. Has red colored bullet plug to main harness, and black plug to PRNDL wiring. Fits 67 CougarFits 67 Mustang

Used wiring pigtail that runs from the under hood harness at the kick panel to the starter solenoid / horn / voltage regulator on the 67 - 68 Cougar.

Emergency or parking brake indicator lamp and wiring harness. Tested and working red indicator light which was found optionally on any 1967 Mercury Cougar standard model 65A or 65C. The 1967 parking brake light kit gets its power from the ignition switch. Ford part number C7WB-10A841-A.

This is the power feed harness that the main console wiring harness C7ZB-13B711-A plugs into, this harness runs under the carpeting to the shifter opening. We offer the main console harness and the jumper harness assembly here.Identified by a blue bullet connector to the under dash wiring harness.

Used radio light socket and wiring pigtail for all factory Philco AM radios as installed in 1967-70 Mercury Cougar and Ford Mustang cars. These light sockets are tested and cleaned, and have enough wiring lead to re-solder or crimp connect to your Philco AM radio. Original part with correct color wire.

Original used AM radio speaker lead wiring harness pigtail for all 1967-70 Mercury Cougar and Ford Mustangs with factory AM radios. We have a limited supply of these but also offer a quality reproduction version of this wiring plug pigtail. Proper length for re-soldering to factory AM radios

Original used speaker lead wiring harness pigtail for all 67 - 68 Cougars and Mustangs with factory AM radios. This wire pigtail is located in the kick panel.*Note - The only difference between this pigtail and the one listed for the 1969-70 dash speaker is the actual plug design.

Used pigtail that runs from the main 14401 harness to the brake light circuit breaker. Works on both standard and XR7.

Used wiring pigtail that runs from the 14401 main harness to the brake light circuit breaker. This pigtail actually feeds the brake switch. Works on both standard and XR7.

Used pigtail that runs from the 14401 harness to either the driver or passenger side door harness for the door ajar.

Used pigtail that runs from the main 14401 harness to the driver side door jamb switch.

Used pigtail that runs from the 14401 main wiring harness to the stop lamp relay / emergency relay / Back up lights on your EARLY 67 Cougar.

Used wiring pigtail that runs from the 14290 under hood harness to the passenger side headlight harness.

Used ignition plug wiring pigtail without resistor wire. Wires can be removed, individual plug also available here.

Used pigtail connection that runs from the main 14401 harness to the K8/9 sequential motor / back up light.

Used under dash wiring harness repair plug and pigtail for the neutral safety switch / back-up lights and engine feed harness for the LATE 1967 Mercury Cougar. Works for both standard and XR7. This is part of the 14401 main under dash wiring harness.*NOTE* The blue/red to yellow/black wire is for the radio feed. The only difference between the early and late harnesses, is the early harness has an extra blue wire.

New wiring pigtail with male bullet connector, and male / female paired connector. Also has rubber grommet that fits a 5/8" inch hole. Looks like 18 gauge wiring. These are remnants from the reproduction Mustang front turn signal lights that we convert to Cougar wiring. Brand new, approximately 13-15 inches in total length. Colors as shown.

Used pigtail that runs from the main 14401 harness to the passenger side door jamb switch.

Original used AM radio power lead wiring harness pigtail for the 67 - 71 Mercury Cougar and Ford Mustangs with factory AM radios. This double male plugged wiring pigtail solders to the your factory Ford AM radio. We have a limited supply of these but also offer a quality reproduction version of this wiring plug pigtail. Proper length for re-soldering to factory AM radios.

Used under dash harness repair plug and pigtail lead to the low fuel sending unit for the Mercury Cougar XR7 or Standard model with the Safety and Convenience option. This is part of the rear wiring harness, plug is at the passenger side kick panel.