Fuel

Made from fuel resistant cork like original.  Modeled off the Mustang \ 69 Cougar gasket which has 5 screws (67-68 Cougar only used 4 screws), but works for any 67-73 Mustang / Cougar. For...

Replaces part #C0AF-9276-A. Goes between fuel sending unit and tank.

Reproduction two hole fuel line grommet for the Mercury Cougar or Ford Mustang.

Exact OEM standards and specifications. Correct fiberglass insulation, fittings, rubber hose and S clip.

This is a 2 piece heat riser choke tube that provides heat to the choke, so the choke will open up as the motor warms up. Made out of Stainless Steel. This tube is designed to work on the 1970,...

Exact OEM standards and specifications for the 429 Cobra Jet / Quadrajet for the 1971 Mercury Cougar or Ford Mustang.

Reproduction spring hose clamp, commonly used on the rubber fuel hoses. Very similar to the OEM Ford factory installed clip. Sold individually, various quantity used depending upon year,...

Reproduction idle mixture screw caps for Holley 4150 carburetors as found on 1967-70 Mercury Cougar and Ford Mustang. All white plastic caps. These were the tamper proof type of caps as...

This part is installed on all XR7 fuel sending units and Cougars and Mustangs with the optional Convenience Control Package. Low quality off shore part that requires soldering to your fuel sending...

Bracket mounts to top of stock cast iron Cleveland intake manifold, holding the throttle cable. Used on both the 351-2V and 351-4V engines with original Ford cast iron intake manifolds. There are...

NOS Motorcraft kit for rebuilding your Ford Autolite or Motorcraft square bore 4300 or 4 barrel carburetor. This kit is not for later spreadbore carburetors. Spreadbore carburetors have much larger...

Basic kit for rebuilding your Ford Autolite or Motorcraft square bore 4300 or 4 barrel carburetor. This kit is not for later spreadbore carburetors. Spreadbore carburetors have much larger secondary...