Interior

Pair of used wire anchors for keeping the rear most headliner bow stationary. These are fragile wires, and prone to rusting. We try to keep them in inventory. 1971-73 anchor wires are 4-9/16 inches...

Contrary to what you might think at first glance, the support rods used in 1971-73 Mercury Cougar / 1971-73 Mustang Coupe headliners are not the same from front to back. Each of the rods is bowed to...

Used hinge for any 1971-73 Mercury Cougar or Ford Mustang. Comes as shown, we select the best hinges to inventory.Replaces Ford part number D1ZZ-6506050-A.

Set comes with economy grade pliers and 150 hog rings, enough for one bucket seat, possilbly two.

This kit contains 500 hog rings, more than enough for two bucket seats and one bench seat.

This linkage fits between the gear at the bottom of the key lock and rod that goes to the ignition switch on the tilt column. *NOTE* For tilt column service, you can contact Tony Augustine at...

New Old Stock Ford Ignition lock set. Lock cylinder only fits 1970-73 Ford steering columns with key lock provision. Factory fresh with two keys. Fits 1970 through 1973's manufactured before...

Ignition lock set is new original from the O.E.M. source. Factory fresh with two keys. Fits 1970 through 1973's manufactured before 5/17/1973. Replaces Ford Part #: D0AZ-11572-A, D2AZ-11582-B,...

Reproduction ignition switch. This is only the electrical side, the mechanical key and lock section is not included. See appropriate shop manual for proper alignment and installation. Follow the...

1971 working, used ignition switch. This is only the electrical side, the mechanical key and lock section is not included. See appropriate shop manual for proper alignment and installation. Tested...

New old stock driver side interior door handle for base Standard model 1971-73 Cougar, 1971-73 Ford Mustang and Maverick and Torino. Ford part number D1AZ-6522601-ANote - Does not fit most...