My Lists
Login
Subtotal
$0.00
Shipping
Tax
Discount
Total
This unique little clip looks a lot like the more common door panel clip but on close inspection you will find it is different. Whereas there are slots for three of these per side, only two per side...
Two of these clips per side are required to hold the interior padded pillar pads the the "A" pillars on your 1968 Cougar.Replaces Ford part number 381896-S2.
This clip is hidden about midway under your console and is used to keep the wire running to the back seat light in place. It attaches to the driver side of the console base. Correct for both XR7 and...
Delicate clip that attaches to a nail-head stud attached to the firewall. Very functional and visible, rather hard to find in unbroken condition.
Exact copy of the hard to find original. This two piece clip is used to mount gas and/or brake line to floor pans.
This clip looks just like the larger quarter extension moulding / trim moulding clip, but is smaller (as our comparison picture shows). One clip per side is used to attach the tail end (smaller end)...
Reproduction large moulding / trim clip for the rear quarter extensions and front fender extensions on the Mercury Cougar. The molding / trim on the 1967-68 rear quarter extension and 1969 front...
This clip looks just like the smaller rear deck / trunk lid moulding clip but is larger (as our comparison picture shows). One clip per side is used to attach the tail end (larger end) of the...
Used grade A rocker panel clip for the 71 - 73 Mercury Cougar
The majority of the rocker moulding end clips we get look like this unit in that the stud is broken or the wire tensioner has been broken off. Putting a new stud in one of these clips is not a hard...
Used plastic clip for the Mercury Cougar or Ford Mustang.
Used Trunk Light Wire Plastic Clip for the 1967 - 1973 Mercury Cougar. For single wire, about 1/4 inch loop. Ford part number 382929-S.
Below are some guides that may help you make the most use of the fastener section of our website.