My Lists
Login
Subtotal
$0.00
Shipping
Tax
Discount
Total
New LED dash light kit for the gauges in your Mercury Cougar. Finally, a kit that will provide you the light you need to see...
Door jamb switch for the 1969 Cougar or Mustang with a tilt column.
May or may not come with original box, guaranteed to be never installed NOS. Ford engineering number stamped on part is C9WY-11652-B
Used headlight switch for the Mercury Cougar. This original FoMoCo unit was tested and will hold 13 pounds of vacuum. The spacer (which is specific to 1969) is not included with this unit, but you...
Highly sought after early FoMoCo replacement horn switch. The later service replacement switches, seen in the 1990s came in a box and were very poor quality. This switch is also superior...
This new old stock intermittent wiper switch has a two speed wiper function, but when turned counter clockwise, it has a rheostat that sets the different delay times. Switches can be physically...
This used intermittent wiper switch has a two speed wiper function, but when turned counter clockwise, it has a rheostat that sets the different delay times. Switches can be physically marked with...
New Old Stock If you have an early 67 the plug may be the dual type which is also listed on this site. This will work with your C-4 or C-6 automatic transmission. Replaces Ford Part #:...
New old stock power window switch, replaces the all of the switches for 1969 and very early 1970. Master switch panel and individual door and rear windows. Replaces C9AZ-14529-D switch....
Compare your switch to these to insure you have the right configuration. Ford engineering number imprinted on the side is C9AB-14529-B.
Replacement USED turn signal switch for your 69 Cougar or Mustang. These switches are tested here at WCCC by our electrical department. If you have replaced your sequential unit in the trunk with...
Requires a $50 refundable core charge, send us your dummy plate for a core refund! No, Mercury never offered an in dash tachometer for your 1969 - 1970 Decor or Standard model Cougar... For years...
This grade "A" taillight wiring harness is a good used harness with no cuts or splices. Not for use with XR7 or Eliminator. The difference between XR7 and standard is that the XR7 has a two wire...