My Lists
Login
Subtotal
$0.00
Shipping
Tax
Discount
Total
New LED dash light kit for the gauges in your STANDARD 67 - 68 Mercury Cougar. Finally, a kit that will provide you the...
New LED dash light kit for the gauges in your Mercury Cougar. Finally, a kit that will provide you the light you need to see...
As the seasoned Cougar owner will quickly point out, there are several differences between the 1967 and 1968 xr7 dash...
As the seasoned Cougar owner will quickly point out, there are several differences between the 1967 and 1968 Standard dash...
New LED dash light kit for the gauges in your Mercury Cougar. Finally, a kit that will provide you the light you need to...
New LED dash light kit for the gauges in your XR7 67 - 68 Mercury Cougar. Finally, a kit that will provide you the light...
Reproduction machined tube seat set, for ram cylinder and control valve on early 1967 Mercury Cougar and Ford Mustang with the 1/4" fittings. This set includes 6 seats, other kits only include...
Reproduction machined tube seat set, for all 1968-70 Mercury Cougar and Ford Mustang. Also some 1967 Cougar or Mustang control valve and ram cylindernwith the 5/16" fittings. This set includes...
This is a cost saving unit when you have a functioning system that just runs slow. The original motor will often make noise and fail to turn in cold weather. This solid state unit will cure that and...
Our turn signal switches are made by the original supplier to Ford from the original tooling. If you have replaced your sequential unit in the trunk with one of our new solid state sequential units...
Replacement U-nut or clip for any 1967-70 Mercury Cougar trunk lid. These slide into the bottom of the trunk lid for attaching the hinges. Correct 5/16-18 threads, 7/8" from center of hole to...
Replaces Ford Part # C1AZ-4529-A Sold individually. All applications, attaches the drive shaft U-Joint to rear end pinion yoke. 5/16 Inch Diameter #24 thread for 1 1/8 inch Bearing Caps.
These coarse thread nuts have an integrated lock washer with serations for the Mercury Cougar or Ford Mustang. They will ONLY work with the U-Bolts used in conjunction with the lowering kits. The...
Sold individually, two per side, four per car required. These often get destroyed when you go to replace your door window regulator slides. Two of these are used to install the C7ZZ-6523288-A track....
Permatex Ultra Copper Sensor Safe High temperature silicone, good for any makes and years. This stuff won't harm your Oxygen Sensors, and is good for up to 700 degrees intermittent.
Just about the only possible reason to put this poor quality reproduction on your Cougar is that it is a good tool to put out engine fires. No Joke! If you happen to have an engine fire you can...