My Lists
Login
Subtotal
$0.00
Shipping
Tax
Discount
Total
Finally, an answer to the much needed, delicate 1968 air conditioning side vents! Visually, these are very hard to tell...
Reproduction plastic plate that goes between the dash bezel and dash pad on any 1967-68 Standard model Mercury Cougar with...
Reproduction A/C center vent for XR7 (non Standard) model Cougars. These are great quality vents with bright chrome...
Reproduction A/C center vent for standard (non XR7) model Cougars. These are great quality vents with bright chrome finish....
Used stamped steel lateral compressor support bracket for Cougars and Mustangs built after 3/1/1968 with the 289 or 302 engine. Very close in design to the 1969 351 Windsor, but smaller overall.Ford...
Used steel lateral support brace for Cougars and Mustangs with the 390-2V, 390-4V, or 428CJ FE engines. Identical to the 1970 FE lateral bracket except 1970 versions have square nuts on the...
Used steel lateral support brace for Cougars and Mustangs with 428CJ FE engines. Fits 1968-70 Ford and Mercury cars all with 390 or 428 engines. Identical to the 1968-69 FE lateral bracket...
Used cast iron pedestal mount for the A/C compressor for Cougars and Mustangs produced after 1/3/1967. This bracket was utilized throughout the entire 1968 model year and is also listed as the...
Cast iron pedestal mount for the air conditioning compressor on all 1967 and 1968 cars with 390-2V, 390-4V, or 428CJ FE engines. Mercury and Ford master part number C7ZZ-2882-A, we suspect that this...
Used mounting plate for the heater blower motor on the 67 - 68 Cougar or Mustang without A/C.
This gasket seals the fresh air tube in the cowl to the heater box inlet on 1967 through 1970 Cougars.
Reproduction plastic plate that goes between the dash bezel and dash pad on any 1967-68 Standard model Mercury Cougar with factory air conditioning. This is for the center vent and is has a Ford...
Used plastic plated plate that goes between the dash bezel and dash pad on any 1967-68 Standard model Mercury Cougar with factory air conditioning. This is for the center vent and is has a Ford...
Push on retainer for heating and air conditioning box levers or shafts. Fits 3/16 inch studs or rods. In most cases you will also want to get a washer to go against the pinched stops. Probably fits...
New push in retainer for any 1967-73 Mercury Cougar or Ford Mustang. These fasteners are used to attach the floor vent / duct to the blower housing, and to connect the defroster assembly to the...
Used push in retainer for any 1967-73 Mercury Cougar or Ford Mustang. These fasteners are used to attach the floor vent / duct to the blower housing, and to connect the defroster assembly to the...