My Lists
Login
Subtotal
$0.00
Shipping
Tax
Discount
Total
Reproduction Dash to Engine Gauge Feed with push-on Post Oil Sender for the 1967 and 1968 Mercury Cougar with the 289 or 302. Red / Green stripe wire = Coil White / Red stripe wire = Oil Lamp...
Reproduction Dash to Engine Gauge Feed with Tach and Slide-on clip Oil Sender for the 1967 and 1968 Mercury Cougar or Mustang with the 289 or 302. * Note - Check the style of oil pressure connector...
Reproduction Dash to Engine Gauge Feed Harness with the push-on post oil sender for the 1967 and 1968 Mercury Cougar or Mustang with the 390, 427 or 428 Big Block. Replaces Ford Part #: C7ZZ-14289-A...
Anti rattle spring for the 1967 Cougar and Mustang clutch release lever spring. Ford part number C6AZ-7562-A.
Air Conditioning Clutch Feed Wire that runs along the driver side valve cover to the clutch on the compressor. About 24 inches in total length. Starting in 1969 the female plug was of the water...
Reproduction console feed harness for the 67 - 68 Cougar or Mustang. This OEM direct fit wiring harness supplies power from the under dash harness to the console harness.
Complete 25 piece clip kit for the 1967 Cougar or Mustang. Keep in mind that this is produced as a Mustang clip kit, and although most clips are the same between Mustang and Cougar...not all...
This Screw fastens the plastic guide for turn signal wires next to column under the cone by steering wheel.
Used black plastic clip for holding the turn signal wiring harness to the column tube, next to the vacuum actuator. Fits any 1967 Mercury Cougar or Ford Mustang with tilt swing away steering...
Master clip kit which includes the following fasteners:Engine bayEngine feedFirewallFront crossmemberParking lightsPassenger side apron below relayRadio cable to dashKeep in mind that not all...
Under dash wiring harness assembly for all 1967 Mercury Cougar and Ford Mustangs with integral, or factory installed air conditioning. All wiring harnesses are test and inspected by our electrical...