Wiring Harness Repair

Used 3 pin connector and light socket harness for the 1967-68 Mercury Cougar overhead console harness for seat belts and door ajar indicators. Blue and red light sockets. These are the same sockets for the seat belt reminder and door ajar warning lights on the ultra rare Safety Convenience Option offered in 1967-68 on both the Cougar and Mustang.

Used 4 pin connector and light socket harness for the 1967-68 Mercury Cougar overhead console harness for parking brake and low fuel indicators. Yellow and green light sockets. These are the same sockets for the parking brake and low fuel warning lights on the ultra rare Safety Convenience Option offered in 1967-68 on both the Cougar and Mustang.

Wiring pigtail for the AMP and Oil gauge cluster from a 1971-73 Mercury Cougar XR7. Pigtail includes the segment of the under dash harness that includes the 4 differently colored 90 degree rubber boot connectors for the gauges, and two light sockets, and at least 8 inches of wire.  Check out this video

Used wire set for the dash plug from the main under dash wiring harness from 69 - 70 Cougar or Mustang. Wire colors may vary. NOTE: When ordering, make sure to leave comment on whether you have a Standard or XR7

Used wire set for the dash plug from the main under dash wiring harness from any 1971-73 Mercury Cougar. Wire colors may vary.

Used fuse block / box with wiring pigtail for the under dash harness for your Mercury Cougar Standard and XR7. This fuse block has a pigtail where the individual fuse holders and wires can be removed. This is also part of the 14401 main under dash wiring harness.Ford part # C6OZ-14A068-A.

Used ignition switch with a resistor wire for the under dash harness of the Mercury Cougar. This unit has a resistor wire that goes through the firewall.

Used under dash wiring harness repair plug and pigtail to the ignition switch for the Mercury Cougar XR7. This is part of the 14401 main under dash wiring harness.

Reproduction pigtail for repairing the ignition switch on the 67 Cougar or Mustang. 

Reproduction wiring pigtail without the resistor wire for repairing ignition switches on 68-69 Cougars and Mustang. NOTE - We've found that the clips on this plug don't lock into the ignition switch and will need to be modified to make fit.

Used voltage regulator plug for the 67 - 68 Mercury Cougar. Plug end only, does not include any wiring.

Used taillight wiring harness repair plug and pigtail to the driver side (left hand) center taillight for the Mercury Cougar. This is part of the 13A449 main taillight wiring harness. *NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of...

Used taillight wiring harness repair plug and pigtail to the driver side (left hand) inboard taillight for the Mercury Cougar. This is part of the 13A449 main taillight wiring harness. *NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of...

Used taillight wiring harness repair plug and pigtail to the driver side (left hand) outboard taillight for the Mercury Cougar. This is part of the 13A449 main taillight wiring harness. *NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of...

Used taillight wiring harness repair plug and pigtail to the passenger side (right hand) inboard taillight for the Mercury Cougar. This is part of the 13A449 main taillight wiring harness. *NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source...

Used taillight wiring harness repair plug and pigtail to the passenger side (right hand) outboard taillight for the Mercury Cougar. This is part of the 13A449 main taillight wiring harness. *NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source...

Used brake switch plug end, the one that plugs into the brake pedal switch for the brake lights. These often times get hot and partially melt. Easy to change, no cutting or splicing of wires. The female spade plug end just releases from the plug end, look for the release tab for beside the wire on the back.

Used resistance wire for the under dash harness from the tachometer through the firewall for the Mercury Cougar XR7.

Used tachometer resistance wire for all 1971-73 Mercury Cougar XR7's and those that wish to add a factory tachometer to your standard instrument cluster. This wiring segment was removed from the main under dash harness of a 1971-73 Mercury Cougar XR7. No wires to splice. This wiring segment includes the plug to the tachometer, lead to the fuse block, and to pins, one goes to the ignition switch, the other goes to the 'thru the firewalll plug'.

Used under dash wiring harness repair plug and pigtail to the ignition switch light socket for the Mercury Cougar. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail to the dash mounted courtesy light on the Mercury Cougar. The socket is the same on both sides. This is part of the 14401 main under dash wiring harness.

Used under dash to under hood connector for the Mercury Cougar. This is part of the 14401 main under dash wiring harness.*NOTE*  This connector comes with the bolt and spring.

Used under dash wiring harness fuse block / box (with a chip or two) with wire leads for the Mercury Cougar STANDARD. This is part of the 14401 main under dash wiring harness. The difference between Standard and XR7 is that the Standard block has the pink resistance wire. *Note - The fuse blocks will have a small amount of damage or chips on it, in spite of what is shown in the picture.

Used fuse block / box and pigtail for the under dash harness on the Mercury Cougar. This is part of the 14401 main under dash wiring harness.Ford part # C6OZ-14A068-A.*NOTE* This unit has the same wire color and configuration as the 1967 version. The only difference is the wire retaining clip.

Used under dash wiring harness fuse block / box (with a chip or two) with wire leads for the Mercury Cougar XR7. This is part of the 14401 main under dash wiring harness. The difference between the XR7 and Standard box is that the Standard box has the pink resistance wire.  *Note - The fuse blocks will have a small amount of damage or chips on it, in spite of what is shown in the picture.

Used wiring pigtail that runs from the under hood harness at the kick panel to the starter solenoid / horn / voltage regulator on the 67 - 68 Cougar.

Used back up light socket and wiring pigtail for the 71 - 73 Cougar.

Used pigtail that runs from the main 14401 harness to the brake light circuit breaker. Works on both standard and XR7.

Used wiring pigtail that runs from the 14401 main harness to the brake light circuit breaker. This pigtail actually feeds the brake switch. Works on both standard and XR7.

Used wiring pigtail that runs from the door jamb to the turn / C pillar light on the 69 standard model Cougar.

Used pigtail that runs from the 14401 main wiring harness to the stop lamp relay / emergency relay / Back up lights on your EARLY 67 Cougar.

Used wiring pigtail that runs from the 14290 under hood harness to the passenger side headlight harness.

Used under dash wiring harness repair plug and pigtail for the neutral safety switch / back-up lights and engine feed harness for the LATE 1967 Mercury Cougar. Works for both standard and XR7. This is part of the 14401 main under dash wiring harness.*NOTE* The blue/red to yellow/black wire is for the radio feed. The only difference between the early and late harnesses, is the early harness has an extra blue wire.

New wiring pigtail with male bullet connector, and male / female paired connector. Also has rubber grommet that fits a 5/8" inch hole. Looks like 18 gauge wiring. These are remnants from the reproduction Mustang front turn signal lights that we convert to Cougar wiring. Brand new, approximately 13-15 inches in total length. Colors as shown.

Used under dash harness repair plug and pigtail lead to the low fuel sending unit for the Mercury Cougar XR7 or Standard model with the Safety and Convenience option. This is part of the rear wiring harness, plug is at the passenger side kick panel. 

Used tach resistance wire that runs from the ignition switch to the fuse block to under hood harness on the 71 Standard Cougar.

Used wiring pigtail that runs from the 14401 under dash wiring harness from the tach to the fuse block and connector (green block behind fuse box) to the under hood harness on the 71 - 73 XR7 Cougar. 

Used taillight wiring harness repair eyelet and pigtail from the circuit breaker to EACH taillight and license plate light. This harness section contains a pink resistor wire which should not be cut or spliced. That is because the wire's ohm resistance is based upon it's length. Cut it, and she's done for. This is part of the 13A449 main taillight wiring harness. *NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject....

Used taillight wiring harness repair plug and pigtail that connects to the 14405 harness to the passenger side (right hand) door jamb from the K8 relay. This is part of the 13A449 main taillight wiring harness. *NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a...

Used taillight wiring harness repair plug and pigtail from the driver side (left hand) C pillar light to the plug at the 14405 harness and driver side door jamb. This is part of the 13A449 main taillight harness.Good for both STD and XR7 models.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no...

Used taillight wiring harness repair pigtail from the K8 relay to the taillight harness plug on the 1967 Mercury Cougar.

Used taillight wiring harness repair eyelet and pigtail that is the ground wire at the fuel filler for the Mercury Cougar. This is part of the 13A449 main taillight wiring harness.Good for both STD and XR7 models.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a...

Used wiring pigtail that runs from the taillight harness ground wire to the K8 / K9 sequential motor. Will work on 67 - 68 Standard and XR7 model Cougars.

Used taillight wiring harness repair plug and pigtail from the K8 relay to the taillights for the Mercury Cougar. This is part of the 13A449 main taillight wiring harness.Good for both Standard and XR7 models*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link...

Used taillight wiring harness repair plug and pigtail for the K8 relay to the taillights for the Mercury Cougar. This is part of the 13A449 main taillight wiring harness.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of information on...

Used taillight wiring harness repair plug and pigtail that connects to the 14405 mid-harness assembly to the passenger side (right hand) door jamb form the K8 relay. The black wire with the blue stripe is for the C pillar lights. This is part of the 13A449 main taillight wiring harness.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid...

Used taillight wiring harness repair eyelet and pigtail power lead from the circuit breaker to the taillights on the Mercury Cougar. This is part of the 13A449 main taillight wiring harness.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source...

Used taillight wiring harness repair plug and pigtail connection at the driver side (left hand) door jamb on the Mercury Cougar. This is part of the 13A449 main taillight wiring harness.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of...