This product has received the 'Crappy Product' certificate.
Items that receive the 'Crappy Product' certificate are products that we carry for comparison purposes as they are often the version offered by other vendors or because it is the only version available. We would not be willing to use these parts on our own cars, and we do not recommend purchasing these parts.
WE ARE NOT ABLE TO ACCEPT RETURNS FOR THESE PARTS.
Product Condition Grades
Below is a general description of what the criteria is for our product condition grades. These are generalizations that are intended to give you an idea of the condition of the product at a quick glance. Because different parts degrade at different rates, there are variances in what the letters represent, please see the products description for details about the condition of any particular product.
A = Excellent / Above Average
B = Average / Some flaws / Good to Excellent Driver Quality
C = Obvious flaws / Poor to Average Driver Quality
D, E, F = Worse, Worser, Worsest
NOTE! When we ship a rear end, we will remove the third member and ship it in a separate box. Some assembly will be required.
Rear axle assembly - Housing, Axles, brake backing plates, and third member. Housing overall width - 54-1/4 inches flange to flange. Spring perches are 43 inches apart on center. 1967 early 9 inch rear end housings had the carry over fill plug in the steel housing as seen from the back of the car. As removed from West Coast Cougar organ donor car. We recommend a bearing and seal inspection prior to use. For safety sake, brake components should never be reused. Standard ring and pinion ratio, non-locking only.
*Note - Brake drums, brake lines, and wheel cylinders, not included.
Bolt pattern is 5 x 4.5