3 Review(s)

Bezel - Horn Panel - Repro ~ 1968 Mercury Cougar / 1968 Ford Mustang

Item #: 13927

Cost: 3360

Earns: 168

Bonus: 0

Reproduction Horn Panel Bezel for the 1968 Mercury Cougar

1968 Mercury Cougar
1968 Ford Mustang

Price: $42.00

Out of Stock Quantity: 0

Availability

Out of Stock - Ships in: Unknown

Applications

1968 Mercury Cougar, 1968 Ford Mustang

Description

Incorrect chrome finish (supposed to be satin not chrome) Mustang part that requires modification to make the metal XR7 insert fit. This is the only new alternative to your broken bezel, we sometimes get in an original that just needs paint. This unit will also fit the Cyclone, Montego, and many other Mercurys and Fords.

Replaces Ford part # C8ZZ-3D572-A.

Shipping Details

Shipping Weight:

0.30 LBS

(weight shown may be the )

Shipping Dimensions:

3 Customer Review(s)

3.33

Out of 5

5 Stars

4 Stars

33%

3 Stars

2 Stars

1 Stars

33%

Write a review!

Read all reviews

Brian

Bezel horn pannel

Bought new horn bezel to replace my old cracked piece. New chrome bezel makes steering wheel look much nicer. Also bought the wood grain decal overlay. Both very nice upgrade. I recommend both.

Reviewed in on 7/15/2020

Andrew

Good shiny replacement

I used this on my '68 Standard restoration, knowing full well that this piece is supposed to be satin silver, rather than chrome. But I like the chrome look, and had the little walking cat emblem "chromed" (vacuum plated) to match. The rubbery vinyl center piece that goes inside this trim was a perfect fit. Fitting this piece into the larger foam and vinyl steering wheel pad was a little less than perfect, but good overall. In my case, it fits a bit tight on the sides, so it's not 100% flush. I think this is more due to shrinkage of the 50 year old steering wheel pad than anything else. Overall this is a good replacement piece if you like the chrome look.

Reviewed Salem, OR in on 3/4/2019

Scott

Very poor quality reproduction warped and too small won't fit original woodgrain insert - don't buy this!

I bought this for my all original black interior low mile1968 XR7. I thought it would be a nice upgrade to the original satin one, which was showing it's age. At the same time, I installed WCCC's wood grain overlay decal. The first thing you will notice is that this C8AA bezel reproduction part is bowed end to end (not flat). This causes the ends to bend inward, and that make it too small to accommodate the original wood grain center insert. And then adding the overlay decal, makes it virtually impossible to install correctly. Initially I tried to install it starting on one end and working to the other. Fail. Then I tried installing the ends first, and working to the center. Fail. I would estimate the part is about 1/8 inch too short. After 30 minutes, I tried to force it flat, and the entire bezel broke in half. I would recommend not buying this. Find an original one, and use chrome paint on it.

Reviewed in on 4/14/2016

Product Questions

Number of questions: 0

Help Improve this Product Listing

I know it is hard to believe, but sometimes we make mistakes.
Other times customers have more knowledge about a particular product than we do.
Again, hard to believe, I know, but it is true.

We greatly appreciate when customers want to help us make our site better.
Because of this, we have developed a way for you to easily send suggestioned improvements to us.

Help us improve this product