My Lists
Login
Subtotal
$0.00
Shipping
Tax
Discount
Total
This die cast bezel with a brushed finish was used from 1969 to the first part of 1970. This is a clean example with no pits or obvious scratches. The engineering number found on the back is...
Poor condition with scratches and pitting as shown. This die cast bezel with a brushed finish was used from 1969 to the first part of 1970. The engineering number found on the back is C8AB-14505-B.
Used grade "A" bezel used on the passenger side door and both rear seat switches. Looks similar to the 1970 bezel but is held in place with very hard to find clips not speed nuts. No pits or obvious...
Good used bezel with obvious scratches and or pits. This bezel was used on the passenger door and both sides of the back seat in 1969 and on some earlier 1970 Cougars. The Ford casting number found...
Used grade B power window switch bezel for the Mercury Cougar. This bezel is used with all the power window switches, except for the driver side door, and was used on the 1973 model only. B grade,...
This kit consists of 3 single switch bezels identified with a D0WB-14507-A casting number and one master switch bezel with a C9AB-14A432-C casting number. You will need to add the black detail paint...
Very hard to find clip that fastens the chrome power window switch bezel to the door panel. Two required per bezel, sold as a pair. Ford part number D0AZ-14570-A. *NOTE* Early 1970 Models used the...
These clips are found on the power window swtiches of the 69 - 70 Cougar. Each power window switch has one of these clips and one of the J hook clips.6 small clips required per master...
These same clips are also found on the four rocker switches located in the center of the 1969-1970 XR7 dash pad. Do not bend the "J" shaped tab any further than is necessary to release the plug from...
This is one of the hardest clips to obtain on any year of Mercury Cougar. Two required per bezel for the three bezels located on the passenger door and the two bezels in the back seat. Do not pry...