Looks great, simple installation but it needs a little bit practice

I purchased these for my XR7 GT that I am restoring. With my wife operating the heat gun on a low setting we started with the center section. It was the smallest section but turned out to be the most difficult one to do. There are several tricks that my wife and I discovered that made the job easier. One trick is to use a deep well socket slightly smaller than the toggle switch depression and after you gently heat up the applique use the drive end of the socket to press the decal into the depression and hold it there while it cools. Another trick is to not trim the edges to the exact size of the opening to be covered. You need to allow about 1/8th of an inch to lap around the opening and fold back over to help "anchor" the decal. To do this gently heat up the decal and at the same time use your fingers to stretch the decal around the parameter of the opening and then back over the back side of the insert.



I would suggest starting with the passenger side insert because it is the easiest to work with and perfect the techniques I have outlined here.



Good Luck!