Beltline Weatherstrip Kit - Door and Quarter Glass - Standard / XR7 - Repro ~ 1967 - 1968 Mercury Cougar

Nice reproduction.

Just did this and they turned out great! A few tips to remember: 1. read instructions but don’t follow them. They say to pry staple while panel is on the car and I’d recommend taking panel off and using an awl and needle nose to straighten the staple ends, first! They will release much easier. It is important to do this on the rear panels made of plastic.
2. To hid the staples in the ‘fuzzies’, just carve a channel in the felt (fuzzies) between the staple posts. You must do this on the rear quarter window felts to get the staple to extend through the thick plastic, so the ends can be bent over. I grabbed it with needle nose and curled it by twisting it, like an alligator would if he grabbed your leg.
3. There was two screws holding the original rubber piece on the outside of the window. One in front and back. I found it necessary to add two more in the middle evenly spaced.

 

This is the only kit to buy for your cougar I bought others but this is the only one that matches the original cougar beltline

The job you have been putting off. Glad I did it. Replace old dried Beltline Weatherstrip on doors and Quarter Glass. No more rattling and now better protect against water intrusion to doors. Nice weekend project parts are quality and fit exact.

This kit has the same sized "staples" to attach the felt to the door panel as it uses for the rear quarter panels. The problem is, the rear quarter panels are a LOT thicker than the metal at the top of the door backer board. Good luck getting the rear quarter felt strips installed with the short staples. How much more could it cost to provide two sets of staples? I'd pay $20 for 8 longer staples if that's what they charged. It was VERY frustrating installing the quarter panel felt. That's why I set the material and fit at one star. Otherwise, it fit fine.