1967 Mercury Cougar

Reproduction white headliner windlace for the driver or passenger side of the Mercury Cougar or Ford Mustang. This unit helps hold the sides of the headliner in place and covers the pinch weld; it is also known as the pinch weld moulding. This is an individual piece and is 7 feet of windlace. You will have to trim this piece to fit and it should be around 6ft each when correctly trimmed. This windlace is correct for 1967-70, however the 1967-68 Cougar with the décor group option used a wider...

Very correct, quality regulator that is much better than the imports we see that are made of a softer metal. Replaces Ford Part # C7ZZ-6523201. *NOTE* The 1967 splined stud the window crank mounts to is taller on the 67 than the 68. They are not meant to interchange 67 to 68. If you install a 1967 regulator on your 1968 the window crank will not seat properly and will protrude from the door panel. If you try to install a 1968 regulator on a 1967 model the window crank will fit too tight to the...

Good used

Good used

C7ZZ-222A55-A Door window rear stop, which installs to the guide (C7ZZ-65222A57). Stop adjusts the door glass in its up most position. One per door, fits left side. This piece falls down inside the door when the rear guide is removed. Bolt included, but may not be exactly as pictured.You can find the reproduction here. Check out our handy diagram below to find other '67-'68 door parts you may need. All the item numbers shown can be typed in to the search bar on our site. (Click image to view...

This is a good used fitting with large and small nipples for use with the foot actuated washer pumps found on 1967-68 Mercury Cougar and Ford Mustang. Good used part that we verify the check valve is working. These screw into of the rubber covered pumps.

This is the bracket on which the windshield washer bag hang on the 1967 Mercury Cougar.  According to Phil Parcells

We shatter the castings from used back-up light assemblies to remove the socket and pigtail complete. This is for the person who has a nice original back up light and is willing to invest the time to repair a damaged pigtail. This light was also used on the 1965-1966 Ford Mustang.

Used wire extension for the tilt / tilt away steering column found in the Mercury Cougar or ford Mustang.

Differs from all other Cougar console wiring in that it has a black plug for the shift indicator light.

This the main under dash harness for the convenience panel that connects to the door harness (door ajar) and low fuel harness. Fits 1967 Mercury Cougar and Ford Mustang. Has low fuel lead for Cougar on driver side, plug for low fuel on passenger side for Mustang. One plug is unused, depending upon application. This is a rare option, indicator lights would be installed in the center section of the dash panel. Unless, air conditioning was installed. If the car had factory A/C and the...

Used grade A standard 14405 harness is inspected, professionally repaired, tested, and ready to install. This harness connects to the main 14401 under dash harness at the passenger side door jamb, and runs through to the trunk. It connects to the sequential unit and the fuel sending unit. These grade "A" harnesses will be uncut and unburnt. This is for those of you who demand excellent original parts for your Cougar.