1970 Ford Mustang

This harness connects the convertible top motor to the under dash convertible top harness under the dash. Fits 1969-70 Mercury Cougar and 1969-70 Ford Mustang. This wire rests in the trough under the passenger side sill plate and goes behind the back seat where the convertible top pump is located.Ford part number C9ZB-15A668-B.

This harness connects the convertible top switch to the pump on both the xr7 and standard 1969 - 1973 convertibles.

This black wire attaches to the Circuit Breaker coming off the starter solenoid on one end then passes through the firewall to mate with the top switch wiring harness at the other end. We believe that some 1969 harnesses may have used a fusible link wiring harness in place of this one. This harness and the circuit breaker can be used on those applications.Ford part number C9ZB-15A669-B or C9ZZ-15A669-B.

Main wiring harness for consoles on 1970 Mercury Cougar and Ford Mustangs. Short harness more of a jumper wire for the ashtray illumination light. Ashtray wiring socket assembly sold separately.Replaces Ford part # D0ZB-14A012-B.

Reproduction dash to console harness for your 69 - 70 Cougar or Mustang.

Grade "A" harness that runs from the passenger side door jamb to the courtesy / C-Pillar light. This harness is only needed if you have a Standard model car. NOTE: All XR7's would have already come equipped with his harness.

For AM radio optional rear speaker. Ford part number C9ZB-18A900-BOverall length: 11' 7"

Wire, or harness, loom plastic clip for any application on Cougars or Mustangs, as well as many other models. This is intended to be a taped onto a wire or bundle of wires. The stem is made for a 9/32" hole for attaching. Can be substituted for a missing Ford clip of approximate size.

Used radio light socket and wiring pigtail for all factory Philco AM radios as installed in 1967-70 Mercury Cougar and Ford Mustang cars. These light sockets are tested and cleaned, and have enough wiring lead to re-solder or crimp connect to your Philco AM radio. Original part with correct color wire.

Original used AM radio speaker lead wiring harness pigtail for all 1967-70 Mercury Cougar and Ford Mustangs with factory AM radios. We have a limited supply of these but also offer a quality reproduction version of this wiring plug pigtail. Proper length for re-soldering to factory AM radios

Original used speaker lead wiring harness pigtail for all 69 - 70 Cougars and Mustangs with factory AM radios. *Note - The only difference between this pigtail and the one listed for the 1967-68 dash speaker is the actual plug design.

Reproduction wiring pigtail for repairing your original 1969-70 heater blower motor with or without air conditioning. Has correct orange and black colored wires. Grommet for motor is 3/8 inch round. Bullet connector on orange wire for use with heater only. Short segment added to orange wire to plug into resistor on A/C. This should also work with 1971-73 fan motors, the wires will be longer though. Orange wire is about 21-1/2 inches long at the bullet connector.Fits: 1969 Mercury...