Your cart is empty!
Our shopping cart requires the use of cookies. If you have your cookies disabled, please enable them for our site to place an order. If you have cookies enabled and have added an item to your cart, but you are still seeing this message, that could indicate that the cookie for our shopping cart is corrupted on your computer.You should be able to fix this by either:
GREAT!
Nice reproduction. Trim the length of the pin on the upper hinges for a more original look.
Great Condition, Very Usable. Good Quality
Items received as ordered and as promised. Thank you WCCC!
Not a bad pin kit however I do think the pin to bushing tolerance could be a little tighter to better match a original that is in good shape. I felt these pin and bushings where just a tad loose but I think they will be ok once installed on the car. Keep in mind the pins are a bit longer then needed so you will need to cut them down once installed. Over all these only took a few mins to install with the hinges off the car
Simple enough to do, parts are good quality and work well
I just rebuilt both drivers side hinges, using this kit and following Don's youtube guide. The parts were a great fit, and the rebuilt hinges are now basically like new. You do need to trim about 3/4" inch off the end - I used a dremel to cut the pin and then ground a taper as per the originals. An improvement to this kit would be to make the pins the correct length with the correct taper for 1968, then no need for trimming.
If you want to reuse your original hinges, then this kit is a must buy to prevent "sagging" doors.
Hard to say anything according to this product, because I didn`t get any pin kit in the sending!
Great fit and great product. Thanks a bunch. Now for another request. It would be great if you guys offered some prints of assemblies on the Cougars.