Fit with no issue, definitely cheap insurance when re-installing the sending unit in the tank.

I suspect that the float in my tank is filling up with fuel, so I picked up a new brass float and this gasket to hopefully correct the problem. I have not installed it yet…but, will first chance I get. Looking forward to getting this job done.

Not much to say other than it sealed the sending unit with out leaks. It is something you should check on after a few years as I had replaced the previous seal about ten years prior and it did not show signs of leaking but broke into pieces as I removed it. I was replacing the original float to get the fuel gauge working..

Seals well. A dab of gasket adhesive holds it in place during install.

Wonderful and way better than goop and junk someone had used to try to seal it with before.

Fit into place just like the one that was in there, little bearing grease holds it in place as you tighten down you ring

Nice reproduction, WCCC has a good video on inatalling the entire fuel system that will guide you.

fine

no problems

FSU Gasket

Quality product, perfect fit.

fuel sending unit gasket

Just what I needed. Thanks WCCC!