The same quality as original if not better! Easy install

Easy to install. I marked the seal for clip locations with a silver Sharpie. Then pinch the seal to push out were clips need to be inserted and then used wire snips to cut little hole to insert the clips easier.

Worked great

I had the original seal on the car when I bought this one. The appearance looks pretty close to the original. I needed to shorten it about a 1/2 inch to be the same length as the original. All the clips were pre-installed so it snapped right in.

Didn't know this part could be obtained! While removing the old parts I ended up damaging the plastic pieces and the rubber seal fell apart. It was a relief to find the parts on this website.

While I can't speak to correctness, this seal fit just fine. It is not pre-punched for the retaining clips, so you'll have to line it up and make your own holes. No big deal.

Like original

I used a drop of adhesive inside the seal on each clip. works great.

As others have mentioned the seal is not marked for the location of the clips. I found that mine were all ~5-3/8 apart so I measured it out, used a pick tool to make a small hole, inserted the T end of the clips, and clipped the seal onto my cowl. It looked good but I did add a few dabs of weatherstripping adhesive between the clips to straighten it out. I honestly have no clue what this seal is supposed to keep in or out of the engine bay but for a few bucks I don't have to look at 7 holes in my cowl anymore!