Welcome to the NEW WCCC Cougar Parts Catalog (Tell us what you think)
Because of extreme wildfire conditions, we are under LIMITED Staff and LIMITED Hours Restrictions.
Orders may be delayed.
We now require a $25 $5* minimum website order (Read More)
loading . . .

Item #: 41609

Login to add this item
to a saved wishlist
Price: $110.85
    Cost: 8868
    Earns: 111
    Bonus: 0


    Normal Stock Item - Next Business Day

    Very nice reproduction of the ram air flapper vacuum motor. Application 1968-1/2 428CJ Cougar and Mustang, 1969-71 Mercury Cougar with ram air, and 1969 Ford Torino 428CJ ram air. Not for shaker ram air systems.

    NOTE: These are manufactured with an extra long shaft to allow you to trim for an exact fit.

    Shipping Weight: 0.30 LBS
    (weight shown may be the dimensional weight)
    (5.00 out of 5 stars) Customer Rating based upon 1 Review(s).

    69 Cyclone CJ

    5.00 out of 5
    The motor I received had a longer vacuum tube than my original and as it is shown in the picture. I found this caused some interference when I tried to install it without taking the hood seal off but when I did I was able to get the mounting holes to line up properly. I considered cutting tube shorter but having it reach out side the seal looked like an advantage to me because it would make removing the hose easier. I had to bend the line slightly for it to go through the hole provided in the seal. This misalignment was what was causing me difficulty in installation when I tried it with the seal on. I can't call this a fault because my original terminated inside the seal leaving no change of interference. I felt confident in the purchase because the ford parts book calls for the same motor for a Cyclone as a 68 Mustang or Cougar. And other than the longer tube, it was a perfect match

    Number of questions: 0
    Please login to ask a question.
    For your convinence, you can view this page on our old site by the following link:
    View Page On Old Site.