My Lists
Login
Subtotal
$0.00
Shipping
Tax
Discount
Total
Ref: Don Rush video on brake distribution block. Mr. Rush; I watched your video and removed my distribution block. The piston was frozen inside the block. Learning from your video I connected my grease gun to the block and popped the piston out in about ten seconds. I also reamed out the blocks cylinder like you did using a wire tube brush purchased from Harbor Freight. My rebuild "o" rings are still enroute from you company to my house. Everything went smooth thus far with the help of your video. I wouldn't have thought of using the grease gun without your insight. Thanks for the help. Good vendor; good video.
The kit works great, the hard part is getting the block off your car, I did it without removing the booster , not fun!
Haven't yet been able to use the brakes but the fit was good and the video instructions helped. Used a bolt to loosen the piston with light tapping of a hammer then pulled it with small needle nose pliers.
O-ring's and copper seal fit my 67 Mustang perfect....! And showed up earlier than expected... Thanks! Dean