Your cart is empty!
Its already starting to bow in the middle. It fit just right I don't think the fiberglass was braced in the middle.
I do like it, seems well made, size and all,have not instaled it yet, but think it will be fine
The scoop fits perfect and looks great. The top fiberglass was a little bit wavey but no problem for my body guy to smooth out perfect, actually I've seen 2 original scoops and they are both wavey originally so its an exact match.
Careful not to overtighten like I did. Pulled thread from fiberglass scoop. Slight wave on one side of the hood scoop, but overall worth the cost and looks really nice.
Good Item overall. Be careful in drilling holes. I drilled the 4 that were punched into the lower hood skin and then aligned up the scoop to mark the others. The hardest part was cutting that hole in a near perfect hood! New intake manifold and 4V carb/air cleaner would not fit under hood. Oops! Remember to not tighten nuts too tight. Just enough to close gap between scoop and hood. They will feel like they could tighten forever. Use some blue loctite if paranoid. Customer Photo: (click on image to enlarge)
Excellent Reproduction in every respect. Priced far better than even used parts in terrible shape from less certain sources. I highly reccomend this item for Cyclone and Eliminator fans
This scoop is great value for money, and is a very accurate replica of the original item. I fitted it to a standard bonnet (hood for you americans) in approximately 1 hour. The mount points are accurate if the studs are glassed in straight, unfortunately three of mine were not and had to be modified slightly. Other than that it is a good quality scoop and looks the part.
ready for paint
Received and on the hood. Looks GREAT Thank You
