Installed unit, hooked all the wiring up as per instructions and turned on the signals. Lights are brighter then with the original unit. Also the inside indicator never blinked, it wanted to but never did. It does now.

It fits right in and replaces all the motors of the old unit

I used the books, read the forums, traced all possible culprits of turn signals not working. I installed the new Solid State unit in the trunk... AND NOW HAVE WORKING SEQUENTIALS! The installation was very straight forward and easy to do. My son and I both replaced the old motors with this box. We have been using them for about a year now with no problems at all.

I couldn't be more happy with this part my old unit was worked and re worked until total failer. The replacement was plug and play all lights work perfectly and are a little brighter.

Once i sorted out the wiring (some one had previously modified the system with some barnyard parts) and installed the unit everything worked great. I also installed some LED signal bulbs which are brighter and look really nice.

Great item! Easy hook up! Replaces old I worn out parts and all you have to do is plug in and taillights work! Can’t go wrong with purchasing this item!!!

Great item! Easy hook up! Replaces old worn out parts and all you have to do is plug in and taillights work! Can’t go wrong with purchasing this item!!!

I ordered this unit and it arrived in two days! That is great!

Installation was easy, even with my old faded original wiring harness in the trunk. I was also missing two of the pigtail plugs, due to prior attempts at bypassing the original unit. All I had to do was use wire studs at the terminal ends of the existing harness, and match the colored coded wires plug them in and that was it! Now even the dash light indicators are functioning properly! Thanks!

Very quick and easy install. It was so fast, i felt like I had done something wrong. Very clear instructions.

My sequential worked, but would the little motor would be finicky. This works great and my volt meter doesn't drop when i hit the brakes.

This unit works great. I also replaced the turn signal relay K-7 with a solid state (13A366).

Manual states to stick the spade connector into the rela connector with the blue wire. I chose a more reliable route: I removed the spade connector from the relay connector, and connected the two directly. I used some heat shrink to keep them safely together and corrosion out.

This works great with regular 1157s. I then upgraded to photon LEDs rear and front, which make a huge difference, especially at daytime.

Great stuff!