Pedal / Linkage/Throttle Brackets

Bracket mounts to top of intake manifold, holding the throttle cable. *Note - Used prior to 3/15/1971.

Bracket that holds the throttle cable for the G code Boss 302 Cougar Eliminators. This is a 1970 part number, it is possible that the 1969 bracket may be either different or had a C9ZZ-9741-? part...

Accelerator pedal shaft assembly that mounts to the engine firewall. For use with 427-4V GT-E Cougars with automatic transmission. We suspect that this bell crank may be slightly different than the...

Accelerator pedal shaft assembly that mounts to the engine firewall. For use with any 1969 Mercury Cougar equipped with factory speed control. *Note - For use with 1969 factory cruise control.

Spring that gives tension to the to your accelerator pedal. We have a limited number of these NOS springs. They came in a bulk FoMoCo package so we cannot offer you the original packaging.

"L" shaped bracket that mounts to the rear carburetor mounting hole for attaching the return spring. Bracket faces forward when installed. *NOTE* This bracket is a bit shorter than the 4V version.

"L" shaped bracket that mounts to the rear carburetor mounting hole for attaching the return spring. Bracket faces forward when installed. *Note - This bracket is a bit longer than the 2V version.

"L" shaped bracket that mounts to the rear of the Holley carburetor mounting hole for attaching the return spring. Bracket faces forward when installed.

Cable length 23.75 inches long. *Note - Used on 429 Cobra Jet Cougars before 4/1/1971.

Cable length 23.75 inches long. *Note - Used on 429 Cobra Jet Cougars after 4/1/1971.

Used throttle cable for all 1969 Mercury Cougar and Ford Mustang with V-8 engines.Very hard to find one year only cable with no cracks. We rarely have this one in stock.

Cable length 22.83 inches long, identified by a plastic ball shaped end attached onto the pedal side of the cable. Must be used with a 1970 accelerator pedal shaft. This is an unbroken part. Notice...