My Lists
Login
Subtotal
$0.00
Shipping
Tax
Discount
Total
Finally, an answer to the much needed, delicate 1968 air conditioning side vents! Visually, these are very hard to tell...
Reproduction plastic plate that goes between the dash bezel and dash pad on any 1967-68 Standard model Mercury Cougar with...
Reproduction A/C center vent for XR7 (non Standard) model Cougars. These are great quality vents with bright chrome...
Reproduction A/C center vent for standard (non XR7) model Cougars. These are great quality vents with bright chrome finish....
Used heater and air conditioning box for late 1967 and 1968 Mercury Cougar and Ford Mustangs. These are getting so hard to find without a broken drain cock or rust in the metal lips. The unit...
Heater control bezel for Mercury Cougars without A/C. Assembly includes grade A bezel, you will want to paint with your exact dash color. Check back often, this type and grade of part is...
Used adjustable idler bracket and one piece pulley assembly for Cougars and Mustangs with the 289 or 302 engine built after 3/1/1968. All pulleys are sold with new bearings installed. If your...
NOS Air conditioning belt tension pulley for Cougars and Mustangs with the 289 or 302 engine built between 1/3/1967 and 3/1/1968. Ford part # C7AZ-8678-B. NOTE* Send in your old core for a...
New old stock bracket and pulley assembly for Cougars or Mustangs equipped with the 289, 302, or 1969 351W engine. We also offer a bearing replacement service to rebuild your 289, 302, or 1969 351W...
24" hose with metal coil (like original) instead of plastic coil found in most. Coils are wrapped in a 6+ mil plastic rather than the 3 mil plastic that you can easily put your thumb through. Does...
Complete foam seal kit for the heater box, flappers, evaporator and heater core on a '67-'68 Cougar or Mustang with factory Air Conditioning. This kit is almost always needed when replacing your...
This reproduction knob set is made by Scott Drake Enterprises. Unlike our knobs, these units have a much larger font. Considering the average Classic Mustang owner is probably 50 years old or more,...
These are correct reproductions of the A/C discharge service valve that comes with plastic caps. if you would like the correct aluminum valves, we sell those separately.
Reproduction A/C suction service valves for Mercury Cougars and Ford Mustangs equipped with factory A/C.
This 1969-70 Mercury Cougar and Ford Mustang shield, was installed at the factory to protect the heater motor from being damaged when the Big Block 390 / 428CJ's were being dropped in. As...
This 1969-70 Mercury Cougar and Ford Mustang short fingered shield, was installed at the factory to protect the heater motor from being damaged when the Big Block 390 / 428CJ's were being...