Electrical & Lighting

Replaces Ford Part # D1ZZ-14305-B Door Tag 65F & 76F

Used XR7 alternator wiring harness for the 1973 Mercury Cougar.  *Will not fit Mustang

Nice reproduction of the original alternator wiring harness, 2 pin dog bone style connector and wire colors match up to the original Ford drawings. Application is 1969 Mercury Cougar XR7 and Eliminator models with factory tachometer, or 1969 Ford Mustang without factory tachometer option, all with Boss 302/351/390/428CJ engines. Ford service number C9ZZ-14305-S. *Caution, not for use with Cougar standard models or Mustang with alternator warning light

Nice reproduction of the original alternator wiring harness, 2 pin dog bone style connector and wire colors match up to the original Ford drawings. Application is 1970 Mercury Cougar XR7 and Eliminator models or 1970 Ford Mustang without factory tachometer option, all with Boss 302/351/428CJ engines. Ford service number D0ZZ-14305-C. *Caution, not for use with Cougar standard models or Mustang with alternator warning light

Nice reproduction of the original alternator wiring harness, has individually colored boots and the wire colors match up to the original Ford drawings. Application is 1967-68 Mercury Cougar XR7 models, all with 289 and 302 engines. Ford service number C7ZZ-14305-B, wire harness marked C7ZB-14305-B or C8WB-14305-C. *Caution, not for use with Cougar standard models. *Note - Excludes California models or cars with factory Thermactor smog pump with low mounted alternators ...

Wiring pigtail for the AMP and Oil gauge cluster from a 1971-73 Mercury Cougar XR7. Pigtail includes the segment of the under dash harness that includes the 4 differently colored 90 degree rubber boot connectors for the gauges, and two light sockets, and at least 8 inches of wire. Check out the video below on our new gauge tester: ...

This is a replica of the warning tag that came on positive (+) terminal of Autolite batteries when the 1967 - 1972 Cougars and Mustangs were shipped from the factory.

The automatic seat back release option for 1971 to early 1972 (before December 1971) Mercury Cougar and Ford Mustang. The automatic seat back release would pull the release lever on both of the bucket seats. This only happens when the either the driver or passenger side door is opened. Kit comes with the 1971- early72 specific wiring harnesses from the solenoid, includes 3 pin switch for the passenger pillar post, relay, solenoids, and cross over wiring. This option is best added to seats...

The automatic seat back release option for 1973 Mercury Cougar and Ford Mustang. The automatic seat back release would pull the release lever on both of the bucket seats. This only happens when the either the driver or passenger side door is opened. Kit comes with the 1973 specific wiring harnesses from the solenoid, includes 3 pin switch for the passenger pillar post, relay, solenoids, plug for retractable seat belts, and cross over wiring. This option is best added to seats prior to...

The automatic seat back release option for Mid 1972 (after December 1971) Mercury Cougar and Ford Mustang. The automatic seat back release would pull the release lever on both of the bucket seats. This only happens when the either the driver or passenger side door is opened. Kit comes with the mid 1972 specific wiring harnesses from the solenoid, includes 3 pin switch for the passenger pillar post, relay, solenoids, plug for retractable seat belts, and cross over wiring. This option is best...

This lens comes without the correct FoMoCo logo, sold individually. Replaces Ford Part # C5ZZ-15514.

These Back-Up Lamp Lenses are exact copies of the originals which come with the FoMoCo Logo. Sold Individually. Includes screws!

Sold individually. Stainless Steel

We are excited to bring these new reproduction chrome backup light bezels for the 1969 and 1970 Mercury Cougar to the market. The sockets, pigtails and lenses are not included so you will need to gently remove your originals and install them in these bezels. You can find the lenses here.

We are excited to bring these new reproduction assemblies for the backup lights for the 1969 and 1970 Mercury Cougar to the market. Includes a pair of bezels with lenses and gaskets. The sockets and pigtails are not included so you will need to gently remove your originals and install them in these bezels.Click on images to enlarge. The chrome finish is brilliant and mirror smooth.  There are no polishing marks like evident on so many of the NOS bezels we see. The lenses have a clear look...

This kit is a time and money saver. Quality chrome bezels and all related parts are included. This is a direct plug-in, no modifications needed.

Hassle free kit makes it easy to install backup lamps. This kit includes mounting pads, lenses, gaskets, T1142 Bulbs and mounting hardware.

Great chrome on this reproduction backup / reverse light for the driver side (left hand) of the Mercury Cougar or Ford Mustang. Lens, gasket, and bulb sold separately. Replaces Ford part # C7ZZ-15512.

Used backup / reverse light for the driver side (left hand) of the Mercury Cougar and Ford Mustang. Lens, gasket, and bulb sold separately, but we do have a kit available. These used lights will often have a minimal amount of pitting on the inside close up to the lens. Casting number as seen on the back side reads C7ZB-15A509-A. Replaces Ford part # C7ZZ-15512.

Great chrome on this reproduction backup / reverse light for the passenger side (right hand) of the the Mercury Cougar or Ford Mustang. Lens, gasket, and bulb sold separately. Replaces Ford part # C7ZZ-15511.

Used backup / reverse light for the passenger side (right hand) of the the Mercury Cougar and Ford Mustang. Lens, gasket, and bulb sold separately, but we do have a kit available. These used lights will often have a minimal amount of pitting on the inside close up to the lens. Perfect inexpensive replacement item for those wanting to keep their car all original and match the overall patina of their low mile car. Casting number as seen on the back side reads C7ZB-15515-A.Replaces Ford part #...

Reproduction backup light mounting spacers for the Mercury Cougar or Ford Mustang.

Reproduction battery heatshield that fits many applications from 70-73, on most hi-performance engines. It was often the first part discarded but serves a real purpose.

Reproduction group 27 battery heat shield that fits many Mercury Cougar and Ford Mustang applications from 1967-70, on most hi-performance engines. It was often the first part discarded but serves a real purpose. Nice American made part, stamped with Ford numbers C7ZB10A682B and C7OB10A682B. There is also a D0... sized for group 24 heat shield offered for 1970-73. *Trivia - these battery heat shields were often trimmed down to fit group 24 batteries.Click on the link below to find some...

Each of these great kits include all three required cables, including part numbers, proper terminal and post clamp ends. Starter cables are properly shielded from heat. Standard Draw pictured above, High Draw pictured to the left. The originals were either 43-55 Amp (Standard) Draw or 65-70 Amp (High) Draw. We recommend going with the High Draw. As one customer put it, "These [standard draw cables] look anemic." (Thanks for the feedback Charles!) Replaces Ford Part # : C7ZZ-14300 ...

Each of these great kits include all three required cables, including part numbers, proper terminal and post clamp ends. Starter cables are properly shielded from heat. The originals were either 43-55 Amp (Standard) Draw or 65-70 Amp (High) Draw. We recommend going with the High Draw. For 1972-73 Mercury Cougar and Ford Mustang all with V-8 engines.Positive cable is 10 1/4" center to centerNegative cable is 42" center to centerGround wire is 41" center to center Replaces Ford Part # :...

Each of these great kits include all three required cables, including part numbers, proper terminal and post clamp ends. Starter cables are properly shielded from heat. For any 1970-71 Mercury Cougar or Ford Mustang with 302 or 351 engine and 43-55 AMP alternators. The originals were either 43-55 Amp (Standard) Draw or 65-70 Amp (High) Draw. We recommend going with the High Draw. As one customer put it, "These [standard draw cables] look anemic." (Thanks for the feedback Charles!) Replaces...

Each of these great kits include all three required cables, including part numbers, proper terminal and post clamp ends. Starter cables are properly shielded from heat. For all 1972-73 Mercury Cougar or Ford Mustang with 43-55 AMP alternators and V-8 engines. The originals were either 43-55 Amp (Standard) Draw or 65-70 Amp (High) Draw. We recommend going with the High Draw. As one customer put it, "These [standard draw cables] look anemic." (Thanks for the feedback Charles!) Replaces Ford Part...

Each of these great kits include all three required cables, including part numbers, proper terminal and post clamp ends. Starter cables are properly shielded from heat. 1970-71 Mercury Cougar with 65-75 AMP alternators and V-8 engines. The originals were either 43-55 Amp (Standard) Draw or 65-75 Amp (High) Draw. We recommend going with the High Draw. As one customer put it, "These [standard draw cables] look anemic." (Thanks for the feedback Charles!) Replaces Ford Part # : D0ZZ-14300 ...

Each of these great OEM Style kits include all three required cables, proper terminal and post clamp ends. Unlike CONCOURS CORRECT cables, these do not have the Ford part numbers on them. Starter cables are properly shielded from heat. The originals were either 43-55 Amp (Standard) Draw or 65-70 Amp (High) Draw. We recommend going with the High Draw. As one customer put it, "These [standard draw cables] look anemic." (Thanks for the feedback Charles!) Replaces Ford Part # : C8ZZ-14300- ...

Each of these great kits include all three required cables, including part numbers, proper terminal and post clamp ends. Starter cables are properly shielded from heat. The originals were either 43-55 Amp (Standard) Draw or 65-70 Amp (High) Draw. We recommend going with the High Draw. As one customer put it, "These [standard draw cables] look anemic." (Thanks for the feedback Charles!) Replaces Ford Part # : C8ZZ-14300

No more crust, white powdery battery terminals. Just spray this stuff on, and after a few minutes....simply wash off with water! Not only can you use this stuff on your car, you can use it on your ATV's, quads, dirt bikes and even your ride on lawnmower! A handy item to have laying around your garage. Of course, there's a little more messy, mostly free alternative which you can find the ingredients for online, but why bother? This is a simple, fairly cheap product to have.  

This battery cover is designed to be used with any maintenance free flat top battery **24/60 series with original terminal location for the Autolite battery covers.

Everything you need to hold the battery down on your 71 -73 Cougar or Mustang. Included in this kit are the two stainless steel J-bolts, the hold down bracket and the hold down clamp.

Reproduction "Battery OK" Decal for the 1967 - 1982 Mercury Cougar / Ford Mustang

Fits Standard and XR7

Perfect fit the first time. You will be happy with this Group 24, quality reproduction and check out the price! These battery trays are a popular item for restorers since most of the originals have been destroyed by leaking batteries over the years. Replaces Ford part #: C7ZZ-10732-D.

Good used group 24 tray for 1968-70 Mercury Cougar or Ford Mustang. Assembly line installed group 24 battery tray, for those that want to keep it very original, this is getting to be a hard to find part with no rot (will show pitting).

This is what I consider to be "Premium Quality". Very correct in every detail and made in the US! The group 27 larger tray was optional on any Cougar and standard on big block Cougars. Replaces Ford part # C9ZZ-10732-AR

NOS service replacement battery tray, may not be exactly like the assembly line tray. Group 27 battery tray is typical for cars with air conditioning and higher amp alternators. Fits 1971-73 Mercury Cougar and Ford Mustang. Also 1970-71 Ford Torino and Mercury Cyclone and variants of the B or C midsize Ford and Mercury bodied cars.  Replaces Ford Part #: D0OZ-10732-B.

Exactly like the originals. This group 27 battery trays are a popular item for restorers since most of the originals have been destroyed by leaking batteries over the years. Fits 1971-73 Mercury Cougar and Ford Mustang. Also 1970-71 Ford Torino and Mercury Cyclone and variants of the B or C midsize Ford and Mercury bodied cars. Supplier misidentifies this part as D1ZZ-10732-B. Replaces Ford Part #: D0OZ-10732-B.

Concourse Correct with 22 & 24 series batteries for Mustang, Cougar and Shelby GT350/500 made in the USA by Mansfield Mustang to orig. Ford Specs includes attaching bolts Replaces Ford Part # C8ZZ-16060-A

Concourse Correct with 22, 24 & 27 series batteries for Mustang, Cougar and Shelby GT350/500 made in the USA to original Ford Specifications, includes attaching bolts. Replaces Ford Part # C9ZZ-16060-A or C9ZZ-16052-P .

Concourse correct with 22 & 24 series batteries for Mustang, Cougar and Shelby GT350/500 made in the USA by Mansfield Mustang to orig. Ford Specs includes attaching bolts Replaces Ford Part # C7ZZ-16060-A

Reproduction Battery Tray Bolts & U Nuts for the 1968 Mercury Cougar / Ford Mustang

Sold as a pair, we suggest you send your cores in advance or at least email us several good quality images if your cores are questionable. If your cores are heavily pitted, cracked or the studs have been over tightened (causes part to dimple / warp) then your cores are not acceptable for restoration. The casting number as seen from the back reads C9WB-15A509-B and C9WB-15515-B. Ford Part # is C9WY-15500-B and C9WY-15500-A

Dash color painted steel bezel that houses the courtesy lights on all 1969-70 Mercury Cougar XR7's. This is the bezel that says MAP COURTESY PANEL ACCY. Sold pit free, often times we can select your desired color, but plan on detailing them if your undergoing a restoration. Mention your color in the comments section of your order. Replaces Ford part number C9WB-10964.

Dash color painted steel bezel that houses the courtesy lights on all 1969-70 Mercury Cougar XR7's. This is the bezel that says MAP COURTESY PANEL ACCY. Sold pit free, often times we can select your desired color, but plan on detailing them if your undergoing a restoration.Replaces Ford part number C9WB-10964. During assembly of your switches, note that the pins need to be on top. Switches and wiring harnesses sold individually. ...