Products (Click sub-categories above to ONLY display results for that Sub-Category) 457-480 of 517
Display Options:
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32701 -
1/4-20 nut with captured washer for installing grilles to headlight buckets. 3 per side, 6 total per car. Sold individually.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32947 -
Individual screw for attaching the headlight retaining ring on any 1967-70 Mercury Cougar or 1965-70 Ford Mustang, and pretty much most all other Fords during those years. #8 stainless steel screw. Two needed per headlight bulb retaining ring. A total of 8 would be needed for a quad headlight system on all Cougars.Replaces Ford part number 375452-S.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32395 -
New slotted pan head screw for mounting distributor points or condensers. Three total, per single advance Ford distributors. We know that these fit FoMoCo, Autolite and Motorcraft marked distributors 1967-73. These are AMK screws 8-32x9/32". Sold individually, but you likely need 3.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32396 -
New slotted pan head screw for mounting distributor vacuum advances. Two total, per Ford distributor. We know that these fit FoMoCo, Autolite and Motorcraft marked distributors 1967-73. These are AMK screws 8-32x1". These are phosphate dipped. Sold individually, but you likely need 2.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32371 -
Reproduction carburetor stud for all Ford numbered Holley carburetors 1967-71. 1/4-20 double ended stud from AMK. Stud only, no wingnut.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32579 -
Hex screw for attaching the black plastic elbow to the right or left hand A/C dash duct. Correct replacement #8 washer head tapping screw. Sold individually, two needed per car. One on each side. Fits 1967-68 Mercury Cougar and Ford Mustang with factory air conditioning.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32569 -
#8 tapping screw for attaching the map pocket to the door panels on any 1967-68 Mercury Cougar XR7. Sold individually, set of 4 needed per car, 2 per side. Chromed, Phillips pan head screw. AMK B-13283.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32169 -
AMK fastener kit for attaching transmission rubber mount. Nuts and washers to fasten to cross member, and bolts to attach to top loader transmission on all 1967-69 Mercury Cougar and Ford Mustang with 390 or 428CJ engines. AMK number F-1741.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32170 -
AMK fastener kit for attaching transmission rubber mount. Nuts and washers to fasten to cross member, and bolts to attach to top loader transmission on all 1967-69 Mercury Cougar and Ford Mustang with 289, 302, 351W, and 351c engines. AMK number F-1414.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32171 -
AMK fastener kit for attaching transmission rubber mount. Nuts and washers to fasten to cross member, and bolts to attach to any automatic transmission on all 1967-69 Mercury Cougar and Ford Mustang with 289, 302, 351W, 351C, 390, 428CJ engines. AMK number F-176.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32175 -
AMK fastener kit for attaching manual transmission clutch Z-bar brackets. 1967-68 Mercury Cougar and Ford Mustang with 289 or 302 engines. AMK number F-867.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32176 -
AMK fastener kit for attaching manual transmission clutch Z-bar brackets. 1967-68 Mercury Cougar and Ford Mustang with 390 or 428CJ engines. AMK number F-866.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32283 -
Brass screw in plug for select Autolite distributor vacuum advance units from 1968-71, typically the banded single advance units factory installed. Solid brass, originals were not, we believe that they were cadmium plated. Solid plug, should be hollow, with a 3/4 inch hex head. Works as it should. Fits most all vacuum advance that have a plug in the end as shown. *Note, when removing the old plug, there is a spring and washer inside.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32389 -
3/8-16x7/8 Bolt for installation of idler, adjusting pulleys, and brackets, on most 1968-73 Mercury Cougar and Ford anything, including Mustang. Sold individually, up to 8-9 are typically used per car. 9/16" hex, washer head bolt.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32390 -
3/8 washer for installation of idler, adjusting pulleys, and brackets, on some 1968-73 Mercury Cougar and Ford anything, including Mustang. Sold individually, 1-2 are typically used per car.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32152 -
AMK reproduction knurled pan head screw for the 1968 Mercury Cougar and Comet / Cyclone fender marker light. There were two different styles of fastener found on 1968 Cougars, was it a plant thing? We aren't sure. Ford part number 372856-S.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32177 -
AMK fastener kit for attaching manual transmission clutch Z-bar brackets. 1969-70 Mercury Cougar and Ford Mustang with 390 or 428CJ engines. AMK number F-473.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32178 -
AMK fastener kit for attaching manual transmission clutch Z-bar brackets. 1969-70 Mercury Cougar and Ford Mustang with 302 or 351 engines. AMK number F-474.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32454 -
Coil bracket mounting bolt for all V-8 engines as found in 1967-73 Mercury Cougar and Ford Mustang. This3/8-16 bolt attaches the coil bracket to various places on the engines. Either on the intake manifold or the cylinder head. Will fit stock Ford cast iron intakes as found 1967-73. AMK bolt B-13722.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 32603 -
Bolt and nut for the clamping the coil into the coil bracket as found in 1967-73 Mercury Cougar and Ford Mustang. Fits all of the various coil brackets used 1967-73 on most all Ford engines. This is a 8-32x1-1/2, 1/4 hex headed fine thread bolt and nut. This is not the round headed slotted screw type that Ford also used.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 20582 -
Features 274 pages / 750 photos/ 12,300 items / history / finishes / measuring and more. This book provides detailed information about the fasteners specified in assembly manuals and parts books. All 12,300 fasteners are referenced to a photo! Must have for anyone wanting to correctly put together a 1955-1973 FoMoCo product.
Wanted!
Buy
Details
Availability: In-Stock Item
Item #: 13007 -
4-Speed shifter rod hardware kit for 67 - 68 Cougars and Mustangs with a 4-speed transmission. Check out our video on rebuilding your shifter below: ...