Convertible

Grade A will be show quality with no scrapes, dents or holes drilled. Keep in mind one can modify a manual window panel to become power. Slightly larger square hole and 'wings' for the Late 1970 Cougar power window switch and bezels.Basic Ford part number 7631005

Includes all five pieces. Front bow rubber seal is C9ZZ-7653986-A. Side rubber seals are C9ZZ-7651564-A, C9ZZ-7651565-A. Much better fit than reproduction, perfect for that high end restoration.

All Cougar, Mustang and Shelby convertibles used this trunk divider board and well (or boot) liner combination in 1969 and 1970. Unlike the 67-68 Mustang trunk divider that screwed to the trunk floor the 69-70 version was stitched to the bottom of the well liner. Held in position by the stitching on the bottom and gravity resting the top of the divider on the trunk lid hinge spring, it was a good clean looking fit.The relief on the bottom was there so you could swing the divider forward to...

Much better fit than the reproductions which make closing your door very difficult for the first year.Ford part # C9ZZ-7602627-A

Much better fit than our reproductions which make closing your door very difficult for the first year. Ford part # C9ZZ-7602626-A

This short section of wiring attaches to the terminal post on the starter solenoid that faces towards the firewall. The other end is a female plug that incorporates a fusible link. If your switch were to get stuck or the frame got in a bind with continued power being applied this is the portion that would blow saving you from a costly wiring "melt-down". This same part was used on both XR7 and standard Cougars with a power sunroof or convertible top.