DUE TO UNFORSEEN CIRCUMSTANCES, THE SUPPLIER WILL NOT BE MAKING THESE MOULDINGS AT THIS TIME. ONCE THEY BEGIN PRODUCTION AGAIN, WE WILL UPDATE OUR LISTING. WE APOLOGIZE FOR ANY INCONVENIENCE.
Complete set with clips. Rocker mouldings are made from stainless steel, we hope to obtain aluminum versions in the near future. These are made one at a time by a true craftsman here in the U.S. Look closely at our pictures below and you will see that every detail is scrutinized over. The more rounded edge mounts towards the rear and the flatter edge mounts towards the front.
Very nice quality set that has been five years in the making! Replaces Ford Part Moulding numbers D0WY-6510176-A and D0WY-6510177-A, four metal clips part number C9WY-6510198-A and 12 plastic clips, Ford part number C9WY-6510182-A.
The pictures below all show the new stainless moulding next to a NOS aluminum moulding. Notice how much nicer the finish is on the ends and how perfect the black stripe is on the repro. Installing these reproduction moulding will in the end be an upgrade to what was installed at the factory. Some refer to this as "over-restoring" your car.
NOS on left, repro on right.
NOS in foreground, Repro in back.
NOS in foreground, Repro in back.
As with the original mouldings (shown above on the left) there will be some degree of variance when looking at the curve as it mounts to the rocker. We inspect every set to make sure it is not noticeable before shipping them.
NOS on right, repro on left.
NOS on right, repro on left.
NOS on right, repro on left.
Each set comes with a template to help you locate the holes for the clips if your car does not currently have the holes located. NOS on right, repro on left.
Notice the hardware kit comes with two extra white plastic clips, only five were used originally.
Replaces Ford Part #: D0WY-6510176-A & D0WY-6510177-A