Power Window Parts

Very heavy duty counter balance spring for all 1969-70 Mercury Cougar door regulators with power windows. Power window regulators only, this spring is quite a bit larger than manual window regulator...

These two switches are mated together but you can separate then from the backside and replace them individually. This double switch is only for the 1969 and early 1970 Cougars. See the bezel styles...

Good used switch ready to install. This is the "NO TAB" version. Tabs are for alignment in power window holders, some have zero, some just 1, and others have 2.They are all practically the same...

Good used switch ready to install. Correct switch for the rear seat area. 

Good used switch ready to install. Correct switch for the passenger side door and rear seat passenger area. Ford part number C9AZ-14529-D, engineering number usually stamped on the side reads...

Reproduction power window switch, replaces the all of the switches for 1969 and very early 1970. Master switch panel and individual door and rear windows. Replaces C9AZ-14529-D switch.However, for...

Replacement power window switch for the passenger door and rear windows on any 1973 Mercury Cougar or Ford Mustang. Should fit other Ford products. Will not fit the master switch panel. Ford part...

Used on the passenger door and both rear windows. This switch can also be found on many FoMoCo products into the 1980's.

Manufacturer calls this a torque pin kit, it consists of 3 pins. Pin diameter is 1/2 inch and are 13/32 inches long. Made from natural nylon. Fits most Ford vehicles with power windows from 1964 -...

Used Bolt-In Design Passenger Side Power Window Regulator for the 1970 Mercury Cougar

Used Bonded Design Passenger Side Power Window Regulator for the 1969 and 1970 Mercury Cougar

Driver side door window regulator with power windows for any 1971-73 Mercury Cougar or Ford Mustang. Original swivel roller is 15/16" diameter.