Please Note:
Many used items in our picture(s) have been cleaned and/or bead blasted prior to being photographed to show condition and detail. The item you receive, in most circumstances, will be pulled from the donor car and shipped to you without being cleaned. We do not retake pictures each time a used item sells. Pictures are a good indicator of what you will receive, but not all used parts age the same. On high dollar parts, email us and we can send a few pictures of the actual part available.
"Core" Items: If we use the word "Core" in the title of the product, the item has been deemed rebuildable, but has not been rebuilt. The item you receive, in most circumstances, will be pulled from the donor car and shipped to you without being cleaned.
This product has received the 'Crappy Product' certificate.
Items that receive the 'Crappy Product' certificate are products that we carry for comparison purposes as they are often the version offered by other vendors or because it is the only version available. We would not be willing to use these parts on our own cars, and we do not recommend purchasing these parts.
WE ARE NOT ABLE TO ACCEPT RETURNS FOR THESE PARTS.
Product Condition Grades
Below is a general description of what the criteria is for our product condition grades. These are generalizations that are intended to give you an idea of the condition of the product at a quick glance. Because different parts degrade at different rates, there are variances in what the letters represent, please see the products description for details about the condition of any particular product.
A = Excellent / Above Average
B = Average / Some flaws / Good to Excellent Driver Quality
C = Obvious flaws / Poor to Average Driver Quality
D, E, F = Worse, Worser, Worsest
This often times missing bracket was attached to the back of your 67 - 68 XR7 model passenger side plastic bezel via plastic studs that easily break off from over tightening the screw. This is the more common design. Two different sized brackets used, this is the larger one that is 1-3/4 inches wide. The bracket that goes in the corner above the switch panel is 3/32" less.
It was obvious what the original intent was on this design in that a tab on the L bracket was supposed to extend into the rectangular hole to keep the bracket properly anchored to the fragile plastic. For some reason the majority of the cars built didn't get the better design. The
repro clips we offer allow you to tighten the screw and not worry about breaking the bracket from the bezel.
Through 67-68, there were four different style brackets, you can see all four by following this link.
Check out our dash bezel repair video: